Electronics Forum | Tue Aug 31 04:33:41 EDT 2010 | eyalg
We are facing 50% yield soldering Linerar (uModule) DC/DC LGA. The failure is characterized as "flactuation of output voltage." Can some one had the same failure?
Electronics Forum | Tue Aug 31 10:37:04 EDT 2010 | dan_ems
Hello, does anyone knows where I can buy from Europe some aluminum tape for attaching thermocouple. Thanks !
Electronics Forum | Wed Sep 01 05:23:08 EDT 2010 | leeg
We are having solder bridges on a fine pitch QFP and was wondering whether printing speed directly affects the bridging and is there a typical formula to work out print speed?
Electronics Forum | Wed Sep 01 05:43:08 EDT 2010 | ranco13
Hi, does anyone has any experience waht so ever with waterman wave soldering with 7 lines of holes? We are now planning to take our assembly line to waterman 7 lines, instead of 5.
Electronics Forum | Wed Sep 01 11:13:23 EDT 2010 | soudomphong
I am looking to replace the flip chip camera for HS60. Does anyone know of a good use camera, and price for it? Thanks, Seth
Electronics Forum | Wed Sep 01 16:33:33 EDT 2010 | smellew
Mike, I don't know this loader, but if you link 3&4 locally on the downstream conveyor, this should make it request PCB from loader via 1 & 2 PCB should then unload.
Electronics Forum | Wed Sep 01 18:14:17 EDT 2010 | swag
We had that happen on rare occasions and got the live vision display back by exiting enhanced board and re-entering or by power cylcing the machine. If that does not work, I don't know how to help you.
Electronics Forum | Thu Sep 02 03:00:59 EDT 2010 | sachu_70
Hi Kevm, would it help to try solderability test of these pads using an agressive flux during soldering? Just a thought.
Electronics Forum | Thu Sep 02 11:45:47 EDT 2010 | kevm
We have tried solderability testing using an agressive flux and have had good results. However, our Mfg process uses laser soldering equipment which is a validated process and we are limited on the type and amount of flux we can use due to ionic cont
Electronics Forum | Fri Sep 03 08:25:30 EDT 2010 | remullis
I removed the muffler yesterday and still had the latch releasing issue, the latch was tight, however the table had some play in it. I adjusted the play out of the table, setup table zero and it fixed the problem. Same symptom as if the latch were lo