Electronics Forum | Wed Apr 16 08:36:51 EDT 2008 | cyber_wolf
Does anyone know of a free reflow profiling training guideline/terminology guide ? I will be training someone from scratch and I would like to give them something to view while I am setting my agenda up.
Electronics Forum | Wed Apr 16 09:30:09 EDT 2008 | swag
IPC-7530 might help some but will cost you a little. We have an older OmniFlo that has a pretty good section on all that in the manual if you happen to have one of those.
Electronics Forum | Thu Apr 17 07:46:22 EDT 2008 | cyber_wolf
CK, I agree with you 100%. I mentioned this to one of my managers....... But, that is what they want. Alll....righty....then...
Electronics Forum | Thu Apr 17 12:27:56 EDT 2008 | samir
Sr. Tech: Here is a decent article by Phil Zarrow: http://smt.pennnet.com/Articles/Article_Display.cfm?Section=Archives⊂section=Display&ARTICLE_ID=80850
Electronics Forum | Thu Apr 17 20:29:35 EDT 2008 | lellis
Follow the traveller as per a engineer there shouldnt be a issue. If the engineer isnt correct the operator isnt to blame, unless they are not following the traveler or paying attention to parameters. Is the messenger to blame, who sent the message?
Electronics Forum | Thu Apr 17 09:57:39 EDT 2008 | bkreiman
Our company is placing an LCD display on boards for a customer and there are questions being raised on the quality level we are getting from our supplier on these LCDs. Does anyone know what an industry-wide quality level for LCD modules should be?
Electronics Forum | Fri Apr 18 14:44:56 EDT 2008 | jax
Saunders Technology... or ECD (makers of M.O.L.E.) has what is called a TEMPROBE that will work how you want... even in "wet" solder paste. Maybe others here can tell you if it works well or not, I use KIC. www.ECD.com/saunders/tp.htm
Electronics Forum | Wed Apr 23 03:19:30 EDT 2008 | jkhiew
Hi all, Can anyone advise me what is the recommended floor life for pcb assembly prior to wave soldering before drying/degassing ? Thks Joseph
Electronics Forum | Wed Apr 23 17:28:46 EDT 2008 | davef
The need to prebake boards to remove moisture from the board [to prevent voiding] prior to wave soldering is driven by the thickness of through hole plating. * 1 thou [25um] or greater requires no prebaking * LT 1 thou [25um] requires prebaking
Electronics Forum | Wed Apr 23 11:28:11 EDT 2008 | jdengler
Did you ask Mirtec? When we were ready to buy a Mirtec they asked if we needed more than normal clearance height. I do not know if this would be retrofitable but maybe you could ask. Jerry
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, 30 China
Phone: +86-138-29839112
