Electronics Forum | Fri Apr 16 15:12:12 EDT 2021 | jsmith01
Does anyone know where the power to the lambda, chip sensors comes from on a Electrovert EPK plus? I have an intermediate issue with these sensors loosing power and the wave just keeps going higher and flows over the pot. I have replaced the senors
Electronics Forum | Mon Sep 25 23:09:24 EDT 2006 | Chris G
I would suggest an Electrovert EPK Plus. It is cheap, easy to maintain, and Electrovert provides good support. You can get a refurbished lead free EPK for less than 50k. They usually come with USI spray fluxers, which is a pretty good thing, and c
Electronics Forum | Thu Nov 25 17:32:54 EST 2010 | padawanlinuxero
Hello !!! Long time since I was here, I have a problem, I use a Electrovert EPK Plus solder wave to solder 8 leads the pcb is like a inche wide and 3/4 or less of height and the leads their size is .3570 inches long by .0195 wide and .0180inches th
Electronics Forum | Wed Oct 31 09:09:35 EDT 2007 | russ
Small waves are fine, biggest problem is the little to no preheat length. This is reason that complex boards cannot be soldered without defects. They also do not handle thick PCBas very well either because of same issue. Most of these "benchtops"
Electronics Forum | Tue Mar 11 18:01:26 EST 2003 | russ
Tim, I cannot remember what model our T.D. wave was it was a small unit about 8 ft. long "tabletop" is what I call them. In keeping up with this thread I noticed a lot of T.D. support. So, I decided to backtrack and review history with my previous pe
Electronics Forum | Tue Jan 28 18:38:36 EST 2003 | joeherz
Mike, I've tried the high side of the flux preheat spec with no success. I did just get off the phone with Electrovert tech support...... Get ready. This machine is configured with a Contour Plus N2 nozzle. We are not running N2. According to M
Electronics Forum | Fri Apr 23 14:14:49 EDT 1999 | Chrys Shea
| Hi everybody, | | I would like to bench mark the quality out of our wave soldering m/c as far as DPPM levels are concerned. Can somebody provide me with some figures at their site or anywhere else for the same. | | Thanks | Upinder | ====== | We
1 |