Electronics Forum | Wed Jan 24 22:38:45 EST 2007 | electrovert
Hello, My first time post up here. I have a problem with thermo runaway on upper zone #5 on the Omni 10 Electrovert. We changed the thermocouple #5 but the problem came back up. We swapped Sensoray board 8 and 9, swapped board #3 (T/C interface boar
Electronics Forum | Sat Jul 01 00:20:08 EDT 2017 | aemery
Kelly, it's been a long while since I repaired a BRAVO. The machine was a little unique as far as Electrovert ovens go. I am pretty sure that it is the only Speedline model that integrated a PLC. Loved the OMNI's, not so much with the Bravos. I a
Electronics Forum | Mon Apr 24 14:04:44 EDT 2006 | pjc
You did not tell us where your boards fit on the thermal mass range. That is key. I've run Pb Free low to medium thermal mass boards with good results on a 5 zone oven (5 top/5 bottom). You should not have a problem running a medium thermal mass boa
Electronics Forum | Thu Feb 10 16:45:36 EST 2005 | pjc
It all depends on what type of board you need to solder. If your boards are small in size and low thermal mass and your conveyor speed requirments are normal, then I'd say the OmniFlo 7 will do the job. It has a max zone temp setting of 280C. The cur
| 1 |
winsouce.jpg)
