Electronics Forum | Wed Dec 08 17:48:18 EST 2010 | katguts69
looking for schematics for electrovert omni 7 reflow oven. manufactured in 1998. help!
Electronics Forum | Thu Dec 09 12:31:39 EST 2010 | travishemen
Mike, I can send you a copy. What is your email address?
Electronics Forum | Tue Sep 06 15:18:01 EDT 2011 | tdhiggins
Mike, I can send you a copy. What is your email > address? Travis, I could use a copy of the manual or parts and pieces of it. Could you send me what you have? tdhiggins@spectek.com thanks, Todd Higgins
Electronics Forum | Mon Jun 24 13:01:24 EDT 2013 | quaker332007
Can anyone help me with the center support on this oven? The support is rising up to high and causing the board to rock during reflow. Is the away to lower the center support?
Electronics Forum | Wed Sep 11 17:16:17 EDT 2013 | saied
Hello, We would like to order this spare-part blower motor electrovert omni Excel for Speedline Technologies Electrovert, type: Omni Excel 7 Serial: 476219 Date: 4/04 and we would be thankful if you provide us the Service manul for your prod
Electronics Forum | Thu Aug 20 11:38:57 EDT 2020 | stephendo
You might have to adjust both ends to match the middle. Is it an autowidth oven?
Electronics Forum | Mon Sep 28 14:27:08 EDT 2009 | soudomphong
I need help with conveyor speed in Omni Excel 7. It fluctuate, and never have a steady speed. I swapped the speed control card,calibrated, encoder, and I still have the same problem. Any help would be appreciated, thanks.
Electronics Forum | Tue Sep 29 07:19:12 EDT 2009 | hussman
Does it ramp up and dowm or do you get a jerk in the conveyor every so often? Jerk in the chain is a sticky link in the chain. Lube may work but if really bad needs replacement.
Electronics Forum | Tue Sep 29 13:03:01 EDT 2009 | soudomphong
Thank you for responding. I called Speedline tech support he think there is a short some where in the motor. I changed the motor out and still have the same problem. The chain is normal, and using automatic lubricating. I will check more into this, a
Electronics Forum | Wed Aug 19 13:52:11 EDT 2020 | goldendragon
Hello guys, Please help me how to parallel the width chain, it is bow out in the middle and keep dropped the board in oven, I can't find anything there that I can manually adjust the middle width to the same size with the entrance and exit. HELP!!! T