Electronics Forum | Thu Nov 01 10:57:34 EDT 2012 | kris1128
Has anyone heard whether the elevation of a plant can effect solder joint formation? One plant at sea level, one at 7,000 feet elevation... same equipment and profiles, big voiding defects at higher elevation. I did a search and found no similar post
Electronics Forum | Fri Apr 20 15:02:16 EDT 2007 | patrickbruneel
Stephen, This is brilliant!! Sorry my elevator is a little slow on Fridays
Electronics Forum | Tue Sep 11 08:36:53 EDT 2007 | cyber_wolf
We seem to have a lot of blowers going bad on our Omni 10 lately. We run PB free and/or elevated sn/pb profiles on a regular basis. I am starting to suspect that the elevated zone temps are causing the blowers to fail. Has anyone else had this prob
Electronics Forum | Fri Nov 05 16:53:39 EST 1999 | Susan Richardson
I am looking for a front elevation of an SMT assembly line beginning with screen printing and ending with AOI inspection. I have searched high and low for a photograph or an illustration representing this process. Can anyone help me?
Electronics Forum | Mon Nov 08 18:05:18 EST 2004 | russ
Looks like we have been running the cure a little short (but only by about 44 min). I need to check if elevated temp shortens cure time to 1 min. at 700F! Thanks Dave, much appreciated Russ
Electronics Forum | Thu Jan 19 05:38:26 EST 2006 | lozlloyd
A bit of a long shot but ... Does any know if Reddish Electronics � SM1500CXE oven is suitable for lead-free soldering ? i.e Can it handle the elevated temperatures ? TIA Steve
Electronics Forum | Fri May 12 08:54:05 EDT 2006 | Rob
Remember, the components' bodies are not going to like the elevated temperatures - you may want to trial a few before you expend too much effort on preforms.
Electronics Forum | Wed Jun 21 13:21:33 EDT 2006 | russ
That is about what I gathered as well grant, if the pb part can withstand the elevated temp of pbfree profile there are no issues Russ
Electronics Forum | Wed Aug 09 04:20:19 EDT 2006 | Rob
If you kink the leads will you be able to insert it without flexing the board/moving any of the other components? Also these pin headers aren't always designed for this process so have you checked that it will take the elevated temperatures?
Electronics Forum | Wed Oct 10 12:20:44 EDT 2007 | slthomas
Does it fail to function or does it function outside of acceptable tolerances? If the latter I wouldn't know what to think, but if the former I would feel obligated to suspect solder quality or maybe even a component problem with the elevated lead-
