Electronics Forum | Mon May 13 14:15:46 EDT 2002 | davef
Entek is Enthone's OSP [organic solderability protection]. It is widely used in the PCB fabrication business. Imidazole (Via Systems) is good, but is not as widely available. Search the fine SMTnet Archive on: * OSP * Entek CU-56, Entek Plus CU-10
Electronics Forum | Mon Jul 22 11:51:28 EDT 2002 | philclegg
Has anyone had experience using Copper Passivate coated PWB's, our supplier calls them "flux coated" but as it's an Organic finish is it handled the same as Entek and where can I get details about it?. I have used Entek CU56 & Entek Plus coated PWB's
Electronics Forum | Tue Jun 05 21:14:10 EDT 2001 | davef
You aren't going to post our stuff on your "Hey, I'm the wizard site", are you? Board fab, Pad coatings, OSP 1 OSPs: Imidazole (Via Systems) is good. Entek (Enthone) works, but requires strict thickness control in fab. 2 Enthone CU56 allows one t
Electronics Forum | Wed Oct 20 17:22:48 EDT 1999 | Dave F
Dunno about 310M flux, but I share your concerns about CU56. You might rethink your selection of solderability perservative, because Enthone: * CU56 allows one thermal cycle. * CU106A allows three thermal cycles. Good luck Dave F
Electronics Forum | Wed Oct 20 16:55:26 EDT 1999 | NickMata
Hello all, I am trying to get some information on ENTEK CU56. I am planning to use 310M flux on ENTEK 56 cards. It will not be a double reflow (top/bottom) followed by wave. I plan to reflow, glue/cure then wave. I am concerned about burning off the
Electronics Forum | Thu Jul 18 21:04:06 EDT 2002 | davef
So, why can't you clean misprints on Entek boards? Entek: Cheap, flat, OK shelf life, not without process and fabrication issues. Your Entek organic solderability protection is probably Entek Plus [CU106A] made by Ethone OMI. Consider getting a co
Electronics Forum | Tue Mar 10 22:16:56 EST 1998 | Steve Gregory
Jeremy, I'm gonna make a couple of assumptions by "reading in between the lines" of your email: 1. You're using no-clean paste. 2. This is only happening on the second side. You tell me if I'm wrong about this... First thing, if you're only experienc
Electronics Forum | Wed Sep 07 16:53:15 EDT 2005 | GS
Contact Cookson Electronic, they can support you with OSP solutions (ENTEK---) new formulations for Lead Free apllication. Regards GS --------- from a 2003 Cookson presentation: Objective Although Existing ENTEK� PLUS CU106A technology is suc
Electronics Forum | Fri Aug 20 00:11:05 EDT 1999 | Rick Holmes
Anyone out there using OSP with double sided reflow and selective solder pallets? I am having trouble testing through what is left of the Entek Plus on the test pads.
Electronics Forum | Fri Aug 20 05:17:25 EDT 1999 | Earl Moon
| Anyone out there using OSP with double sided reflow and selective solder pallets? I am having trouble testing through what is left of the Entek Plus on the test pads. | Think rotary. Earl Moon