Electronics Forum | Tue May 02 14:19:26 EDT 2000 | Bill Schreiber
There are two primary causes of epoxy adhesive bond failure, heat and over exposure to moisture. Ultrasonic cavitation is a only a mechanical "scrubbing" action on a microscopic level. However, if the adhesive bond is week or has small areas of det
Electronics Forum | Fri Aug 07 02:32:09 EDT 1998 | P.L. Sorenson - Technical Consultant
| | | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and
Electronics Forum | Thu Aug 06 12:49:41 EDT 1998 | justin medernach
| I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and the
Electronics Forum | Mon Aug 24 07:16:52 EDT 1998 | Paul Horan
| | | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and
Electronics Forum | Thu Aug 06 10:30:41 EDT 1998 | Mike
| | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and t
Electronics Forum | Mon Aug 24 07:12:20 EDT 1998 | Paul Horan
| | | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and
Electronics Forum | Fri Aug 07 01:02:51 EDT 1998 | zeek - just wanna to get a word in here
| | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and t
Electronics Forum | Thu Jul 06 02:08:27 EDT 2000 | Ralph Landry
I need to build a couple of prototype SMT boards and need some recomendations on some adhesive or epoxy to use to hold the parts down prior to hot air soldering. I find that some parts want to skip across the board when heated, or they want to walk
Electronics Forum | Tue Dec 14 13:26:19 EST 2004 | Peter
I have a question regarding post cured property of SMT adhesive. If after component placement, the epoxy dot gets compressed and bridges between the 2 pads, what would the impact on the circuitry? Would it pose risk for flux entrapment? Could the cu
Electronics Forum | Fri Apr 30 08:28:39 EDT 2004 | davef
Roger Saunders, President Saunders Technology, Inc wrote a fairly unbiased paper that compared different thermocouple attach methods. You can probably find it on their site. In it, about gluing thermocouples, he says: There are two general classes