Electronics Forum | Tue Apr 25 18:51:06 EDT 2000 | Steve Thomas
We have quite a few stencils that either are debonding, have debonded, or we suspect will debond when we can least afford for it to happen. The epoxy is coming loose from the foil, but remains attached to the webbing. All the stencils that are comi
Electronics Forum | Wed Mar 25 03:27:13 EDT 2015 | slave2anubis
Hi davef, thank you for sharing this. Yes all manufacturers recommend their products, and i dont deny that they are good but for a small shop like i have i think the prices are a bit high. What i think would be a good technique, is heating the area t
Electronics Forum | Thu Dec 07 19:54:55 EST 2006 | davef
We agree with "guest" above. This a "chip bonder" type material used to improve the reliability of array type devices. "A relative comparison of the N50 values is given below: No underfill = 1.0X (baseline) Corner bond = 1.3X Non reworkable underfi
Electronics Forum | Tue Aug 30 10:48:18 EDT 2005 | cmiller
If you do not have a lot of TH joints there are some advantages. No boards "submarined" in solder pot on wave. You can solder the bottome side SMT parts rather than epoxy them when the parts are put down. This should reduce SMT defects and missing pa
Electronics Forum | Wed Jan 22 14:14:56 EST 2003 | Stephen
Most of the design considerations will be for the wave soldering of the SMT parts. Have you considered selective soldering pallets or masking as an alternative? One problem I have seen with the epoxy process is parts that are high off the board and t
Electronics Forum | Wed May 07 09:31:28 EDT 2003 | davef
We use uV Dymax glue for thermocouple attach sometimes, but don't like the remainder [anal] and loosing attach, sometimes. Roger Saunders, President Saunders Technology, Inc; said: PRO: � These products are easier to use than high temperature solde
Electronics Forum | Wed Apr 11 14:05:30 EDT 2001 | davef
No, there's not a really great epoxy product for attaching thermocouples in reflow. Specifically, what's your problem? From Sanders Temprobe verbage ... Adhesives There are two general classes of material commonly used to adhesive bond thermoc
Electronics Forum | Fri Apr 30 08:28:39 EDT 2004 | davef
Roger Saunders, President Saunders Technology, Inc wrote a fairly unbiased paper that compared different thermocouple attach methods. You can probably find it on their site. In it, about gluing thermocouples, he says: There are two general classes
Electronics Forum | Tue Feb 08 14:49:23 EST 2000 | Travis Slaughter
I have never tried this and wouldn�t really even want to consider it. Epoxy generally cures at around 160c in a fairly short amount of time, solder paste requires much more time and a peek temperature of about 210c or more in some cases. Curing you
Electronics Forum | Fri Oct 06 05:56:37 EDT 2000 | Alberto Silva
Hi, Instead of using High Temp solder, I would like to use a UV epoxy to atach termocouples to reflow profile boards. Does any one know a good one? Thanks in advance. Alberto