Electronics Forum | Tue Feb 22 22:39:22 EST 2022 | cirsol
Hi, Sorry I didn't see your previous post. I do have an update but will answer your questions first. {So you only rebuilt the MC HDD and didn't rebuild the Station PC? Am I right ?} Yes that's correct, we only rebuilt the MC HDD but were not able t
Electronics Forum | Wed Oct 12 17:45:07 EDT 2022 | rmcmartin
I received an error message from our Sony F209 pick and place machine saying E17 servo controller is in emergency stop. It says the remedy is to cancel the input or replace the cable. where is the E17 servo controller and how do you cancel the inpu
Electronics Forum | Thu May 10 05:46:29 EDT 2018 | ringelgr
Hi We are using a Sony SI-F209,yesterday we encounter strange error. The machine fails to start any servo motors and we get the message shown at the attachment. Hope someone can figure it out cause we're really stuck right now. We spoke with the com
Electronics Forum | Fri May 25 05:44:18 EDT 2018 | ringelgr
OK guys i finally traced the error it was the R-Axis motor rolling bearing. It broke so the motor could not start.
Electronics Forum | Fri May 11 02:19:19 EDT 2018 | bukas
hi, what have you already done to resolve this? is this MC library a file you can locate? if yes, try replacing it with backup. corrupted databases and libraries can cause such failures.
Electronics Forum | Fri May 11 03:03:35 EDT 2018 | ringelgr
The first time i resolved it i just did a normal maintenance and i thought that the motors where overloaded from old grease. But now this is not the case cause this came just 2 weeks after the maintenance.
Electronics Forum | Fri May 11 03:19:20 EDT 2018 | ringelgr
The first time i resolved it i just did a normal maintenance and i thought that the motors where overloaded from old grease. But now this is not the case cause this came just 2 weeks after the maintenance.
Electronics Forum | Fri May 11 05:30:35 EDT 2018 | bukas
and during that normal maintenance did you move motor cables and connectors? or motor controller board cables/connectors? you need to give us some more info on what you did there...
Electronics Forum | Fri May 11 05:46:01 EDT 2018 | ringelgr
No i didn't move any cable just cleaned the old grease and applied a new one, also checked the tension of the belts and cleaned the inside of the machine. In any case no cables where moved at the maintenance process. And the only info i have is the
| 1 |
