Electronics Forum | Tue Jun 21 07:44:13 EDT 2005 | bobpan
Usually the machines come with a manual that lists the error codes. Does the error happen at random??? Is it related to one head??? What does the error say in Mr. Terminal??
Electronics Forum | Thu Jul 30 08:36:29 EDT 2015 | kevinb
I have a K&S 7500 dicing saw with an error code. It reads (F005 system environment is not correct-reinstall system). There is no more support for this machine and I would like to find some help with my problem
Electronics Forum | Mon Jun 20 18:36:42 EDT 2005 | jsloot
Does anyone have any experience with a QUAD Meridian 1010? Our company has purchased a used machine. We have it installed and running almost smoothly. Getting an error code 3487, description is "Z axis target position in motion board is strange" Anyo
Electronics Forum | Thu Oct 06 17:34:07 EDT 2011 | jrsmachine
Hello Tom. Thks for your response. I tryed all your suggestions. No luck. This is how it happened: Several weeks ago I allowed an inexperienced unsupervised operator to work on some program changes. When I checked back afew hours later I noticed
Electronics Forum | Fri Jul 07 17:33:25 EDT 2023 | jdengler
Since you haven't received any useful advise I will throw my 2 cents in. I do not know this machine but in general what you describe is an axis that does not get it's home pulse in time. Many machines will have an in-range sensor that gets flagged
Electronics Forum | Wed Jun 28 22:42:34 EDT 2023 | unsung
I work on a few of these Universal machines before. Check your severos ( I believe their 6 of them ) in the back of the machines all of them should be on. If you see a red light on one of them it's gone bad and that's your Y axis card. It's easy to
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Mon Jul 10 13:57:21 EDT 2023 | ttheis
We were able to get the machine to zero after 'scrubbing' the encoder head. We used a piece of paper towel and IPA and slipped it between the head and the scale. We moved it back and forth a few times to clean the head then blew out any remaining dus
Electronics Forum | Sat Jul 08 02:21:40 EDT 2023 | unsung
I did clean the gold strip and black encoder box pretty good it took me a few trys but it work ( it did had rust on the machine from the rain I guess... from being out side for awhile)
Electronics Forum | Tue Jun 27 05:28:32 EDT 2023 | ttheis
We powered up our Advantis machine after leaving off for several months. When we powered it up went to zero it we get an error on the y1 axis during zeroing. Command move home: pattern step 0. The y negative limit is hit during homing, the axis then