Electronics Forum | Fri Jan 27 16:42:29 EST 2023 | dilogic
We have odd problem with zeroing of UIC Advantis (4982B). It performs axis zeroing without complaining (all axes enabled at the end), but after final move of the head to the center of the machine, it hangs without any error message. Status isshowing
Electronics Forum | Mon Sep 30 16:36:00 EDT 2013 | richardconnell
I have a Universal Instruments Corporation TAB Bonder. Oldish machine. Initial fault on machine : - "Axis Head 1 Z DAC Limit error during move absolute command" Other fault seen after we reset power, Zeroed axis etc. - Axis Head 1 - Z error not re
Electronics Forum | Tue Oct 01 18:44:24 EDT 2013 | richardconnell
Hi, I have limited capability on the Z axis. The axis will home to the mechanical switch limit and then drop to a point which I asssume to be the fiorst zero point below the mechanical switch limit. Then it gives the error. There is power to the mo
Electronics Forum | Tue Jun 27 05:28:32 EDT 2023 | ttheis
We powered up our Advantis machine after leaving off for several months. When we powered it up went to zero it we get an error on the y1 axis during zeroing. Command move home: pattern step 0. The y negative limit is hit during homing, the axis then
Electronics Forum | Wed Feb 02 08:11:03 EST 2022 | openindus
Thanks for the answer. Our camera doesn't even move during USC Park initialization. I assume it's a condition which isn't met to launch the sequence, but all the sensors seems to be fine. Could you send me the log (SECSDBUG.TXT) of your machine dur
Electronics Forum | Thu Dec 30 20:48:09 EST 2021 | openindus
We acquired the machine few weeks ago and it was working fine until the printer won't initialize anymore with "USC park failed" error. It seems that the printer won't respond to "4 MAXY_SP 61,0" message. Is someone has already en
Electronics Forum | Thu Jan 13 19:39:57 EST 2022 | openindus
Nobody have any answer on this issue? We are really strugling with that since begining of this year.
Electronics Forum | Tue Feb 01 19:02:48 EST 2022 | proceng1
USC PArk is your underside stencil cleaner. The camera pushes it back and a magnet grabs it and holds it back. Ours did this many years ago. I pulled the rear cover and initialized the machine, when the camera pushes the stencil back, grab it and
Electronics Forum | Tue Feb 01 18:50:39 EST 2022 | proceng1
Did you get this figured out? I just took two Accuflexs out of service and I still have one in service. Tell me more about the issue. I may also have parts if you need anything.
Electronics Forum | Wed Feb 02 08:12:58 EST 2022 | openindus
And the offer for spare parts is much appreciated. We have the nuts on the automatic conveyor systems that seems to be a little of tolerance. I will get back to you if we can't fix that with new parts.
