Electronics Forum | Thu Aug 08 06:00:05 EDT 2013 | sarason
This is a message from probably a C++ Compiler telling the programmer that a program loop has incorrect data. In all probability a Borland Compiler error message. This fault should not of escaped from the completed application. This stuff is meant to
Electronics Forum | Thu Oct 26 12:14:34 EDT 2017 | lefwan
Our DEK 265 machine is showing this error message during starting…than it keeps re-starting in endless loops: Diskette drive failure on drive A Fixed Disk Controller Failure Fast ready check - Version 1.0 Copyright Arcom Control Systems Ltd. CMOS
Electronics Forum | Wed Oct 26 22:31:48 EDT 2022 | sarason
Broken wire connecting to the encoder on your servo, or anyware else in the feedback loop?, bent up encoder? sarason
Electronics Forum | Wed Oct 26 22:32:26 EDT 2022 | sarason
Broken wire connecting to the encoder on your servo, or anyware else in the feedback loop?, bent up encoder? sarason
Electronics Forum | Fri Jun 03 11:13:28 EDT 2011 | jeremymc
I've been running a MYDATA TP11 for over a year now and yesterday when I turned it on I was given an error that I have never seen before. It had been a week since the last time I had used the machine and when it was turned on it told me that there
Electronics Forum | Mon Feb 07 08:26:38 EST 2022 | micropak
So you only rebuilt the MC HDD and didn't rebuild the Station PC? Am I right ? The Installer Floppy disks for MC software will install a default IP address and the Node Name. You have to change not only the IP addresses (in HOSTS file) but also the
Electronics Forum | Tue Feb 22 22:39:22 EST 2022 | cirsol
Hi, Sorry I didn't see your previous post. I do have an update but will answer your questions first. {So you only rebuilt the MC HDD and didn't rebuild the Station PC? Am I right ?} Yes that's correct, we only rebuilt the MC HDD but were not able t
Electronics Forum | Wed Nov 05 11:57:43 EST 2008 | gidster
Help please, Has any body got any ideas what could be causing the Optical loop errors, I have checked the operation manual and all it tells me is to switch off once. Any help would be appreciated as it's started to drive me up the wall thanks in adva
Electronics Forum | Mon Sep 20 14:15:32 EDT 2010 | dekhead
"System Suspended While Cover is Opened" indicates front or rear cover opened; not the head being raised. Therefore there is an issue with one of the cover interlocks not being made properly. Note there are 2 switches on each (NO and NC) one goes int
Electronics Forum | Thu Feb 29 13:42:53 EST 2024 | mistrthou
I'd be looking at the safety circuit as a whole. Grab a multimeter and make sure you get a full closed loop back to the safety relay, and see if the safety relay itself didn't go bad.
