Electronics Forum | Tue Nov 03 12:21:53 EST 1998 | phillip hunter
| Thanks for your reply. | I am interested in knowing about maintenance schedules and levels. I'm wondering how to know if I must replace a part. What part? What type of lubrication (for Fuji). Etc. | My company is small in terms of number of lines
Electronics Forum | Fri Nov 20 23:00:07 EST 1998 | David Lombard
| | Thanks for your reply. | | I am interested in knowing about maintenance schedules and levels. I'm wondering how to know if I must replace a part. What part? What type of lubrication (for Fuji). Etc. | | My company is small in terms of number of
Electronics Forum | Wed Jun 09 10:41:28 EDT 2010 | chrislyttle
We've been having some problems with out Fuji IP2E machine that we've recently bought from a company that is no longer operating here. Since installing it we've encountered a few problems with it starting up. To give you a quick breakdown of its be
Electronics Forum | Wed Apr 22 12:50:39 EDT 2020 | rodrigo
Hi all, One of our Fuji CP-642 machines has a weird problem. It does not happen every time but often enough that it is a problem. I power up and press start to zero it. The problem is the zero...ing does not finish. It moves the xy-table, D1/D2 table
Electronics Forum | Fri Apr 16 17:44:40 EDT 2010 | rodrigo
We're still trying to fix a C-axis overflow error in our CP-65. I was swapping servo boards and one of them started to blinks a 2 on the LED single digit display and the machine didn't boot up. I replaced the servo board with a spare we bought on eba
Electronics Forum | Sun Jan 23 00:57:23 EST 2011 | bvdb
Hi Jerry, Happy New Year. Thanks for your suggestions. You were on the right track because I remembered that one of the last things that happened before the error message started showing up was that I cut and removed the empty tape from the back o
Electronics Forum | Thu Jan 20 07:58:46 EST 2011 | jdengler
Hi Bert, Take all feeders off of the machine. Do a reset start (hold reset switch in while powering up the machine). This will flush the memory so you will need to load PROPER, STATUS, PROGRAM. If it still does it you may have a short in a feede
Electronics Forum | Wed Jul 07 11:40:32 EDT 2010 | daxman
Huh... Can you maybe explain a bit more? Are you getting this error on the IP3 monitor or on the programming computer? Do you use MCS, Fuji Cam or Flexa? Will the machine start up and zero-set? At which point of the power-up does the error arise? Are
Electronics Forum | Fri May 06 16:19:40 EDT 2005 | jdengler
Does the problem happen at start-up? Does the servo amp have an error? If yes to both, could be a bad cable, or a badly tuned servo amp. If after running and the amp has an error it could still be the cable but also brings in things like a bad motor
Electronics Forum | Tue Jun 20 19:12:41 EDT 2023 | madisreivik
Hello all ! FUJI IP3 starts up, makes zero setting OK But if I start AUTO mode, it gives error -------------------------------------------------------------------------------- Code 11082010 UsedBy MTU3,MTU4,MTU5 Display Usable Proper Data has