Electronics Forum | Tue Apr 13 14:49:15 EDT 2010 | davef
90%) from the sample, and the bake time and temperature specified herein are minimums. To improve test accuracy, or to prevent heat damage, other bake parameters may be AABUS. 2 Applicable Documents IPC-QL-653 Certification of Facilities that Inspect
Electronics Forum | Fri Apr 22 16:53:37 EDT 2005 | rsmith@z-mar.com
Wrist straps are used to bring the operator to ground potential which is the same potential as the dissipative worksurface and the electronic device which is on the bench. Everything must be at the same elctrical potential. Wireless straps will not d
Electronics Forum | Wed Feb 02 06:58:07 EST 2011 | mikeyjryan
Hello, The company I work for are located in the North of Spain and the humidity levels in the factory range from 10 to 60 %RH. We have concerns about the low humidity effects on our ESD controls and want to invest in a system to keep the humidity a
Electronics Forum | Mon Aug 14 11:18:42 EDT 2000 | Chris C
There are two similar products, Eureka and McDry dry box units and other nitrogen required units in the market. Both Eureka and McDry are not required Nitrogen, I'm seeing a cost saving there in the long run. I have several Eureka dry box in the faci
Electronics Forum | Mon May 06 21:40:40 EDT 2013 | davef
ANSI/J-STD-001: * Temperature and Humidity: 18-30°C, 30-70%RH ** If out of range, shall verify electrostatic discharge control program according to ANSI/ESD S20-20 is adequate. ** For process control, more restrictive temperature and humidity limits
Electronics Forum | Thu Apr 12 13:04:47 EDT 2007 | slthomas
Handling requirements of all classifications of moisture sensitive devices is found in J-STD-033. It really isn't an issue for most parts unless they're going to reach reflow temperature again, which is unlikely unless you're removing a nearby compo
Electronics Forum | Thu Apr 12 22:00:58 EDT 2007 | davef
Search the fine SMTnet Archives, for instance: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=46687
Electronics Forum | Thu Apr 12 00:56:20 EDT 2007 | Jani
Our SMT production and storage area is air-conditioned, constant temperature is maintained but the humidity is not controlled , the raw SMT material is stored in a "Drier" cabinet, but since we assemble hybrid SMT and thru-hole PCB assemblies, the SM
Electronics Forum | Tue Aug 04 23:50:20 EDT 2015 | johnwnz
Hi folks, I was wondering what the combined wisdom was on the humidity effect on the MSD control required by the Jedec std. The std works on a relative humidity of 65%, if my RH is only say 30% because of factory environments how do I easily factor
Electronics Forum | Fri Sep 18 07:59:38 EDT 2015 | mun4o
Thanks FCM, we remove the metal plate and make a new ferro-concrete base.Under foot put ESD rubber.Now machine working perfect - without any vibration. Thank you very much and success.