Electronics Forum | Mon Aug 20 14:39:42 EDT 2012 | davef
Investigate these links * http://www.ehow.com/how_12128475_determine-number-parts-partial-reel.html * http://ox3.com/pprX.php
Electronics Forum | Mon Aug 20 07:17:36 EDT 2012 | ericrr
Hi we have Juki KE-750L's is there any program to work out how many parts left on the reel, on the machine, the placement program does have a option to keep this number, but once you finish the run and start a new run the figure is lost. Unless I mis
Electronics Forum | Wed Aug 22 07:24:34 EDT 2012 | ericrr
how about this for resistor & capactors with 4mm pitch, all measurements in millimeters. cell A1 "Input inside diameter" answer in cell B1 cell A2 "Input outside diameter"answer in cell B2 cell A3 "Input layer width,(from inner to outside layer) (no
Electronics Forum | Tue Sep 18 10:52:14 EDT 2012 | sarason
Sounds like a plan. The usual way is to count how many you use on the job either by pre-calculation. Or how many clicks the machine counts and save the data before switch off, then drop it back into a spread sheet. This depends very much on the mach
Electronics Forum | Mon Dec 07 17:11:41 EST 2009 | stepheniii
This happens on the counting area which it is > into warehouse , Have you confirmed that? Have you seen empty pockets? Or are you taking someone's word for that? How many extra parts does the stockroom give to SMT to cover droppage?
Electronics Forum | Mon Jan 06 18:01:01 EST 2003 | dougt
This is getting deep but here's my input: Here's an idea....... Get a full reel and weigh it on a parts scale down in the stock room. Next weigh an empty reel. Subtract empty from full, and devide this value by the quantity of the full reel. This
Electronics Forum | Tue May 14 18:07:27 EDT 2002 | soupatech
My method is not good if accuracy is an issue. Most of our reels come with a guage on the back. It is not a perfect count but with a good eye you can get within a couple hundred on reels of 5k. On the reels shipped with no guage I usually just hold a
Electronics Forum | Tue May 14 12:28:30 EDT 2002 | yquem
Does anyone have a template or a method of approximating remaining part count on a started reel? We are not ready to purchase an electronic parts counter at this point
Electronics Forum | Wed May 02 09:25:09 EDT 2012 | tbouslog
Our company has recently changed the way our cage gives our SMT Department their parts to try to better control inventory. SMT now instead of recieving reels recieves strips with only 2-20 extra parts depending and the size/cost of the part. Does any
Electronics Forum | Tue May 14 20:45:45 EDT 2002 | davef
Ashok Dhawan, an old friend of SMTnet, says: Formula for counting components on SMT tape & reels [spiral belt]: Length = Number of turns * 1/2 * 22/7 * ( dia outer + dia inner), where ... Number of turns = ( dia outer - dia inner) / thickness of
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411