Electronics Forum | Fri Jan 29 11:23:54 EST 2010 | ppwlee
Smtnet, I am looking at pros and cons for automated soldering. The application is a simple multi pin through-hole soldering on a high volume manual assembly line. The goal was to eliminate defects associated with missing solder pins which goes undet
Electronics Forum | Wed Feb 07 07:58:58 EST 2007 | ayelet
Thank you guys. So to summarize - no spec, just need to have decent cleaning... Are you familiar with dust events that caused burning of test stations ? Thanks Ayelet
Electronics Forum | Mon Jun 28 13:41:19 EDT 1999 | mike weekes
I am looking to buy either a GenRad TestStation 80 or a HP 3170 test station. GenRad has matched HPs price, but I'm concerned about the HP UNIX vs GenRad NT base - any input on your choice and service, support, cost, issues, satisfaction - email me
Electronics Forum | Sun Jun 07 19:09:21 EDT 1998 | Graham Naisbitt
Chiakl Ion Chromatography has been perfectly described by Dave, but here are a couple of extra considerations: Ion Chromatography will tell you precisely what is present on the surface of your board/assembly but it will not tell you whether it will b
Electronics Forum | Mon Jun 08 20:03:07 EDT 1998 | Dave F
| Chiakl | Ion Chromatography has been perfectly described by Dave, but here are a couple of extra considerations: | Ion Chromatography will tell you precisely what is present on the surface of your board/assembly but it will not tell you whether it
Electronics Forum | Mon Mar 11 13:36:28 EDT 2013 | babe7362000
To get rid of the old info as far as the electrical test and so forth, just try to type in the pick number in CC, it should erase that extra info that you do not need. Do this after you uploaded your information. Hope this helps.
Electronics Forum | Mon Mar 11 13:46:14 EDT 2013 | ngineer
Michelle, I've tried this, and the extra information goes away, until you save and then access the pick and place data again, then it is back.
Electronics Forum | Mon Mar 11 13:27:56 EDT 2013 | ngineer
Bobpan, I have found the same, although this issue is different. If go to one of those lines in CC, and delete it, then replace it with a pick 9, then save it, i go back to the pick table, and it shows the same lead inspection electrical test, et
Electronics Forum | Tue Jul 12 09:51:42 EDT 2005 | russ
We use the JBC irons with and without the "leadfree" tips. We really have not noticed much difference between the standard and the lead free. The lead free tips do last a little longer but the tips are somewhat deformed by the extra plating. As f
Electronics Forum | Tue Jan 29 09:59:36 EST 2008 | ashley
hello Vikkaraja, your machine failed to pickup & centering test refuses to stop because the machine cannot determine which Head is currently at which station. on Head A, there is this little "dog" that cuts a sensor somewhere at station 9 on your ma
.png)