Electronics Forum | Wed Mar 23 20:13:19 EDT 2016 | ttheis
UPDATE: For anyone experiencing similar issues it looks like it is bad axis control card(s.) It would make sense since that is what the message said... A red "fail" led was overlooked on one of the cards apparently. I had this same issue with anothe
Electronics Forum | Mon Jul 21 06:18:15 EDT 2014 | digar
We had this. The anti-backlash nuts were binding. > We took them apart, chased the threads with a tap > and re-assembled with slightly less pre-load. > Hasn't been a problem since. > We had this. The anti-backlash nuts were binding. > We took t
Electronics Forum | Fri Nov 19 15:29:25 EST 2004 | JB
"Wondering if there's an easy solution to save a product along with component database to disk, and load the product directly from there?" The program that you have on your GSM should be the last known good program right? So why would you want to sa
Electronics Forum | Fri Feb 12 19:40:42 EST 2010 | rodrigo
I posted the message below on Friday and today Monday I started looking at the problem again. We have a computer with a setup that works. It is the original PC we bought with the F4G but it is set up for a machine we do now have ,IP3. I was looking a
Electronics Forum | Thu Feb 06 17:46:33 EST 2014 | escalador
Do You know what is the purpose of slot 12 card, the third one?I it has the fail led on after startup so it cannot pass the machine model loading stage.
Electronics Forum | Sat Aug 08 09:45:11 EDT 2015 | edwaterfall01
It would be helpful to know what happened before the error occurred. Do you have another machine so that you can swap some boards? The Force CPU, (machine controller) located in the VME, is responsible for controlling all machine-related activities.
Electronics Forum | Mon Mar 05 07:53:28 EST 2018 | wolverine55
Hello All We have a Universal Model 6287A that is estimated to be about 25 years old. It has run fine for most of it's life but recently has stopped communicating with it's host computer, whenever any commands were attempted to be sent to the machine
Electronics Forum | Fri Jun 04 10:02:06 EDT 1999 | Chrys Shea
| | I'm encountering a new problem at my new company that I haven't encountered before in my past life - and that's Wave Soldering VIA holes. | | | | We've been getting a rash of defects that we call in this company, "insufficient solder in VIA hole
Electronics Forum | Fri Jun 04 17:10:59 EDT 1999 | C.K.
| | | I'm encountering a new problem at my new company that I haven't encountered before in my past life - and that's Wave Soldering VIA holes. | | | | | | We've been getting a rash of defects that we call in this company, "insufficient solder in VI
Electronics Forum | Tue Jun 08 11:40:03 EDT 1999 | Steve Skinner
| | | I'm encountering a new problem at my new company that I haven't encountered before in my past life - and that's Wave Soldering VIA holes. | | | | | | We've been getting a rash of defects that we call in this company, "insufficient solder in VI
.gif)
