186 fee cp, cp642, cp642, cp642, cp7 results

Electronics Forum: fee cp

CP642 Ballscrew Replacement

Electronics Forum | Thu Jun 25 08:34:31 EDT 2009 | cyber_wolf

Banging and knocking is not good. The noise that we hear on ours is more of a whining. .1mm runout and rough edges = time to replace in my opinion.

Fuji CP642 Station 17 Help

Electronics Forum | Sun Jul 11 21:10:27 EDT 2010 | fujiphil

First, check the sensors for 17th and 19th station....tune the sensor amplifier if necessary. Then, check the dogs on the nozzle holders... If the above, items are ok... check the 13th station clutch engagement. Calibrate if necessary... fujiphil

Fuji CP642 Station 17 Help

Electronics Forum | Tue Jul 13 10:51:55 EDT 2010 | muarty

Sounds pretty much like the sensors/amplifiers need tuned on your machine. It is a fairly straightforward exercise to do this. The sensors basically look at the back of the chucks to determine which nozzle is in the lowest position and therefore whic

Fuji CP642 Hardware NG issue

Electronics Forum | Wed Apr 16 16:58:00 EDT 2014 | jimmyboz

My first guess, loose wire or bad cable. Email me and I will send you a checklist.

looking for any body that works on old Panasonic MV, Fuji CP642, Speedline MPM 2000 and 3000

Electronics Forum | Mon Jun 29 09:23:59 EDT 2015 | tnisbet

We service MPM machines. Tom Nisbet tom@goppm.com 603 765-8814 www.goppm.com

looking for any body that works on old Panasonic MV, Fuji CP642, Speedline MPM 2000 and 3000

Electronics Forum | Mon Aug 29 13:34:58 EDT 2016 | mhanrahan

We had this issue with our old MV 150. This was usually due to clogged/dirty or bent nozzles, or clogged dirty filters on the vacuum supply to the head.

CP-642: What reset nozzles at start of nozzle centering?

Electronics Forum | Fri Mar 23 07:55:20 EDT 2018 | cyber_wolf

The shafts are not going to origin during zero set. Take a look at your station 12 sensors and fiber units.

CP-642 sometimes does not finish power up sequence. It hangs.

Electronics Forum | Fri Apr 24 17:42:04 EDT 2020 | rodrigo

I checked and the fine theta motor is spinning. Thank you so much for the help.

FUJI CP642 narrow camera flicker

Electronics Forum | Sat Dec 16 09:43:39 EST 2023 | madisreivik

I know, but actually we have very "deep knowledge" of that machine, probably much deeper than we wanted :) So, if any information about nozzles please share !