Electronics Forum: feeder material (Page 1 of 8)

Quad IV-c feeder error

Electronics Forum | Sun Feb 03 09:36:29 EST 2019 | bobpan

Good job.... Sorry i didnt see this post...some of us were busy snow tubing over the weekend...haha. Many times over the years....the rubber belt inside the feeder will deposit material inside. Sometimes it ends up on the sensors and blocks the ligh

3d printing Quad feeder rollers

Electronics Forum | Fri Jan 06 18:20:01 EST 2017 | sarason

AS wonderful as your experiment in 3D printing is. WOuld you have been better off taking a print feeder roller out of an inkjet , with the right diameter and cutting to size on a dropsaw! Another approach is to find a supplier in the printing indust

IQ smart feeder maint and calibration

Electronics Forum | Wed Mar 19 18:40:03 EDT 2014 | guts1872

We use IQ feeders from PPM and cant find any reference material on maintenance and calibration of these feeders. Does anyone here know where I can get repair manuals, diagrams, or any info on these feeders at all?

IQ smart feeder maint and calibration

Electronics Forum | Thu Mar 20 14:58:04 EDT 2014 | aybars

We use IQ feeders from PPM and cant find any > reference material on maintenance and calibration > of these feeders. Does anyone here know where I > can get repair manuals, diagrams, or any info on > these feeders at all? Hi guts1782, IQ feed

Re: check feeder cpt tracking on SMT lines

Electronics Forum | Fri Jul 16 17:49:06 EDT 1999 | JohnW

| | Hello, | | i'm looking for informations about companies which are using system to verify the loadind of a SMT machine by using barcode (on the slot on the machine & on the reel). | | I'm in charge of the installation of this kind of system. | |

Re: check feeder cpt tracking on SMT lines

Electronics Forum | Mon Jul 26 03:32:31 EDT 1999 | Jason

| | | Hello, | | | i'm looking for informations about companies which are using system to verify the loadind of a SMT machine by using barcode (on the slot on the machine & on the reel). | | | I'm in charge of the installation of this kind of system

Defect in diode(Reverse Polarity)

Electronics Forum | Wed Jun 07 18:02:49 EDT 2023 | linux

incoming material. bad feeder. set rotate before recognition

Cover tape not always pulling back on Fuji IP-1

Electronics Forum | Thu Jun 15 03:31:26 EDT 2006 | Bert van den Berg

The cover tape on 0805, 1206 and IC reels occasionally does not pull back clear of the tape and our Fuji IP-1 stops. Although some feeders appear to be more vulnerable to this than others, is this a feeder problem or is this a material problem with

SMT EQUIPMENT FOR LOW VOLUME HIGH MIX

Electronics Forum | Mon Apr 28 11:52:28 EDT 2003 | hruiz

Thanks for your responses, as gregp says, one hour in changeover is not good when you run only 10 panels, we alredy do from 10 panels to 2500 boards per run, depends on the product, we already have a pre-kitted area mounted in their respective feeder

DIP insertion and Axial insertion old equipment poka yoke

Electronics Forum | Fri Jan 31 13:45:49 EST 2020 | slthomas

We had a custom bar code storage and feeder setup. Stores material handlers would bring the parts to the line, scan the part number on the kanban card (always accompanied the parts), and the storage location LED flashed so they knew where the place

  1 2 3 4 5 6 7 8 Next

feeder material searches for Companies, Equipment, Machines, Suppliers & Information