Electronics Forum | Wed Jan 25 13:29:14 EST 2017 | emeto
you can check several things here: 1.Is this original tape or it is tape and reel service? 2. Is the cover tape that sticky, to lift component a little bit(sometimes might get the hole component). 3. Hole too loose, allow it to move too much 4. Fee
Electronics Forum | Fri Jul 19 14:54:41 EDT 2013 | dontfeedphils
I suppose I worded that poorly, we run a B2 bench-top unit later on in the process (QA area to be exact) so it isn't in line with anything and doesn't have to keep up with anything feeding it upstream. And we run Juki equipment.
Electronics Forum | Fri Jul 19 10:01:30 EDT 2013 | dontfeedphils
In a past life I ran F1 systems post placement / pre reflow behind a MyData My12E, so it didn't exactly have to keep up with a speedy chip shooter, but it did pretty well. The AOI would end up being the bottle neck some of the time, but not because
Electronics Forum | Wed Dec 14 13:11:27 EST 2005 | grantp
Hi, Thanks for the ideas, and I liked URL's idea of seeing if we can move the in feed sensor, that might hold the board wile the other is feeding in. Our in feed conveyer is also much faster than the oven, and I wonder if we can change that. I will
Electronics Forum | Tue Dec 13 12:56:17 EST 2005 | grantp
Hi, We have a problem sometimes where our soltec oven will accept another PCB too soon after it's taken the last one, so the PCB will collide with the last PCB that just enter the oven, and knock half the components off one of the boards, and destro
Electronics Forum | Tue Feb 04 21:07:16 EST 2014 | sarason
You should ask yourself a bunch of questions before you consider going down this path. The first being where are the bottlenecks in your existing line and is there anything you can do to eliminate or decrease there bottleneckness (made up word). I
Electronics Forum | Wed Jul 13 09:38:21 EDT 2022 | madisreivik
Page 18 http://www.mpk-pcb.de/en/download/mpk-kemmer-pcb-tools-catalogue-2019/ And maybe try "downforce" EA30-L type, as the cutting path is very short. Short lengths you can cut dry. Just use manufacturers recommended feed/speed and DO NOT reduce
Electronics Forum | Tue Feb 07 15:50:13 EST 2017 | proy
Can anyone recommend starting points for feeds and speeds in machining durastone pallet material using a CNC routertable? Cutter suggestions as well.
Electronics Forum | Tue Jul 19 12:36:03 EDT 2016 | jbuckley
My company uses both Juki electric and mechanical feeders. Yes, electric feeders are much more efficient than mechanical as far as pick speed and general feed speed. However, if a reel runs out, it usually takes our operators under a minute to change
Electronics Forum | Fri Oct 15 11:32:04 EDT 2010 | patrickbruneel
Inspecting for plating problems shouldn’t be part of incoming inspection. Your board manufacturer should have the appropriate process control. I shouldn’t have said barrel cracks but plating skips. Plating skips are caused by dull drills or a too hi
