Electronics Forum | Fri Aug 01 11:57:56 EDT 2014 | kurtiss
It turns out it was a misaligned fiber sensor on station 12?, the after rotation nozzle verification.
Electronics Forum | Sat Nov 19 18:35:39 EST 2011 | johndoe0222
We have an old Fuji GSP III-4000 we just changed the fiber sensor on the in-bound and outbound of the printer. The problem we are having now is the board would only go midway the table and it would go up. It does not even reach the main stopper and t
Electronics Forum | Tue Jul 05 17:09:40 EDT 2022 | madisreivik
PROBLEM SOLVED :) ! I messed with parameters, then started to check hardware again. and.... There are 2 transport position on the carrier 1) vacuum 2) mech clamp Both have fiber position sensor which shows the status When there is component, the
Electronics Forum | Thu Aug 18 12:46:43 EDT 2011 | jdengler
In the center of the head shaft there is a rod that is used to flag 2 sensors at the top of the shaft. This lets the machine know when a nozzle is attached. Check that the sensors are working correctly and the rod moves freely. The sensors are fib
Electronics Forum | Fri Mar 23 07:55:20 EDT 2018 | cyber_wolf
The shafts are not going to origin during zero set. Take a look at your station 12 sensors and fiber units.
Electronics Forum | Tue Mar 28 19:28:54 EDT 2017 | aemery
Giao, These style of MPM's use stepper motors, but no feedback like an encoder or a resolver. In other words all axis positions are assumed after "Reset" of the machine. Because of this style of drive system there is the potential for the vision ga
Electronics Forum | Wed Feb 01 00:10:32 EST 2006 | kent
Are you seeing this problem with the nozzles after an error stop? Well check station 15 confirm nozzle clutch origin. It will cause this problem. If you rotate a shaft (with the machine stopped) 45 degrees and start you will get return theta off and
Electronics Forum | Sat Apr 03 16:39:15 EST 2004 | stefwitt
We had a similar system on the Siemens machines, quite some time ago. However, it was not a laser light but a LED and a fiber cable. Actually the center fiber or receiver was surrounded by a bundle of small fibers for the LED light source. You may al
Electronics Forum | Wed May 15 08:04:27 EDT 2024 | james2024
Hello, The fiber optics cable appears to be functioning correctly; transmission is evident through the blinking LEDs, and the computer can read the status of all transport sensors. I have managed to identify an error in the logs. Please use the foll
Electronics Forum | Fri Apr 24 07:27:28 EDT 2009 | jdengler
Hi Nick, I took a feeder that was broken and modified it. I glued shims in place to set the sensor height with. I glued a block of metal to work as a stop for the Y axis. Then for the rotation I use a piece of paper to see were the emitter is poi
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
