Electronics Forum | Thu Jun 05 21:59:22 EDT 2008 | mika
bsumfg, The very best anybody said lately!! This should go straight into the the manual! I totally agree with you; Just an add: The fid's should never be mistaken for a test point who normally is between 1.0 - 1.27 mm so make the fids 1.5 mm. round
Electronics Forum | Thu Nov 30 11:30:31 EST 2006 | billwestiet
I like this definition the best. After years of sales of pick and place and other, this is always still a topic of discussion. If your customer's cycle time involves building a board in two different machines, then I would suggest measuring and add
| 1 |
winsouce.jpg)
.gif)
