Electronics Forum | Mon May 21 10:25:16 EDT 2012 | swag
Ask for board fiducials if you're running arrays. Global fids on the panel do not work well. One handy product we use on flex is "Tacsil". Works well on SMT pallets as well as router operation. It's double sticky stuff that helps hold on to the P
Electronics Forum | Tue Aug 19 14:16:51 EDT 2008 | jax
It depends on whether the Fiducials are Circuit Fiducials (located on the PCB) or Block Fiducials (located on the Panel) His way would be for Block Fiducials.
Electronics Forum | Tue Aug 19 13:35:51 EDT 2008 | stefi
Hello, I need an advice regarding the next issue: in the case of Assembleon Topaz or Emerald SMT machines, is there necessary to teach first the block repeat coordinates and after that the PCB fiducial coordinates when you do not have these coordina
Electronics Forum | Fri Aug 22 15:26:18 EDT 2008 | rway
I rarely use blk fiducials. But when I do, they are always programmed after the fids. It's the fids that sets your general alignment of the panel. I only use blk fidus for thin pcbs (30 mil) that tend to warp when on the conveyor.
Electronics Forum | Thu Aug 21 19:18:47 EDT 2008 | duchoang
My steps are different in that case: 1- Check mounts. Try to adjust origin point until get the pretty good mount positions. 2- Teach fiducials ( Board fids, not panel fids) 3- Use fids, check mount again. 4- If OK, then teach Block Repeat. This alwas
Electronics Forum | Fri Aug 22 15:27:13 EDT 2008 | wayne123
this is the order that I use. 1. Teach pcb origin 2. Teach fiducial location 3. dial in vision on fid in mark info. 4. go into mount and verify that the primary image is on in x/y (after perfoming a teach trace condition) and then do any offsetts if
Electronics Forum | Thu Aug 27 09:04:54 EDT 2015 | fcmtechnician
HI are the LED from Ilumination on?
Electronics Forum | Thu Jul 30 07:25:09 EDT 2015 | buckcho
Hello, I haven't worked with such machine, but do you have a led lighting, like in cp45, which is newer? Maybe there is something wrong with it and it is not lighting up?
Electronics Forum | Wed Jul 29 10:27:01 EDT 2015 | risorse_new
Goodmornin I have a problem with the fixing and move cameras, i don't see the image of the cameras on the screen. On the monitor i see the cross and letter, but i can no see on the black box the camera images. I know the problem is on the ADDA Board.
Electronics Forum | Mon Sep 21 04:23:16 EDT 2009 | smtbox
R series Features FCS (Flex Calibration System) highly regarded easy maintenance just got even easier! The optional FCS calibration jig is a simple to use system to re-calibrate placement accuracy. The machine automatically picks and places jig comp
.gif)
winsouce.jpg)