Electronics Forum | Sun Jan 24 08:48:43 EST 2021 | dilogic
GSM's have MMIT I/O bus. It is used for most of the discrete I/O, so I would check it's operation first - see attached diagram. You sholud have BUSPROBE tool which you can use to read/write memory locations directly. I do not know if you have access
Electronics Forum | Mon Jan 28 03:00:24 EST 2019 | nikevoo1
The problem was in mechanical valve O-rings. I replaced the valves and the problem disappeared.
Electronics Forum | Wed Jan 23 11:14:11 EST 2019 | assuredtech
Do you have a spare head? or have you tried swapping the head to a different module? Is it always the same component (element)? Inspect the component under a scope / perhaps a packaging / adhesive issue. If the component is staying on the nozzle what
Electronics Forum | Tue Jan 22 20:39:04 EST 2019 | nikevoo1
Hello, The problem is with NXT head H04. So there are 4 nozzles that take elements and place them on the PCB.The problem is that it does not randomly place the already taken element on the PCB.The nozzle take element and going to place it, but does't
Electronics Forum | Wed Jan 23 18:57:09 EST 2019 | nikevoo1
Is it possible to have too much grease on mechanical valves and because of that something has been clogged? Or mechanical valve O-rings to be a problem? https://imgur.com/a/ZHShMAH https://imgur.com/a/SzAWIL0
Electronics Forum | Wed Jan 23 20:01:20 EST 2019 | padawanlinuxero
Hello Sounds to me that the problem might be with vaccum and lot of it, after the component is place theres a small amount of air that pushes the component away from the nozzle in MYDATA we call it a kiss in my facility, have you check that the air
Electronics Forum | Wed Jan 23 12:49:44 EST 2019 | nikevoo1
next step, if the nozzle have to take the same component, the nozzle is going to take it and the both components stick together(one over the other) and the nozzle places them like this stick together. So there is nothing in one place, and on another
Electronics Forum | Wed Jan 30 00:56:00 EST 2019 | kiransahu
Sounds to me that the issue may be with vacuum and part of it, after the segment is put there's a little measure of air that pushes the segment far from the spout in MYDATA we consider it a kiss in my office, have you watch that the air that "puffs"
Electronics Forum | Thu Sep 13 17:29:02 EDT 2007 | fnorradd
I am currently having a problem with uncut legs on one side of axial components from a universal dual head insertion machine. Initially it was thought that the anvil on one side was engaging slow so I stripped down and changed the seals in the botto
Electronics Forum | Mon Sep 20 00:51:03 EDT 2010 | jeffr
This particular Yamaha Head I/O Board is a common failure. Yamaha supply an updated version which is less likely to fail. The cause of the problem that you see is due to the connectors on the flexing and damaging the inner layers of the board. The on
