Electronics Forum | Thu Jul 29 21:12:55 EDT 2004 | davef
Use a spray fluxer, like those used in wave soldering. Search the fine SMTnet Archives for supplier names. We understand that spray fluxing is significantly different than dispensing. What do you want/expect to accomplish by dispensing liquid flux
Electronics Forum | Wed Jul 28 11:47:16 EDT 2004 | GCronin
I am looking for a consistent method of applying no clean liquid flux to solder pads. My main concern is if I use a standard air-over type dispenser mounted to an automated arm that the liquid flux will make a mess and not be consistent. I'm not to
Electronics Forum | Thu Aug 05 12:02:48 EDT 2004 | Vince W
Go on the WEB and do a search of "Spray Fluxing" Several options should show up Good luck with your search
Electronics Forum | Wed Jan 17 21:40:49 EST 2007 | Sumbi
Oven keeps building up debri in cooling plates and flux system seems not very good. would preferr less maintance,no time. know of any work arounds.Oven is Paragon series.
Electronics Forum | Tue Jan 23 23:28:54 EST 2007 | jovial_guy23
If you have flux deposits on the cooling plates, try out Zestron's VIGON RC101...It is an extremely good product especially for reflow ovens and wave solder systems. Check it out...Minimal maintenance water based chemistry with no flash point...Much
Electronics Forum | Wed Jan 17 22:35:21 EST 2007 | JNet
Is the oven air or nitrogen? If it is air I would suggest more exhuast to pull the flux vapors out if the oven before they can condense in the cooling. If it is a nitrogn machine that makes it a little more complicated. If the filter system is clogge
Electronics Forum | Thu Apr 09 12:13:22 EDT 1998 | raymond
What is the pro & con of using flux dispensing vs flux dipping method for flip chip assembly ?
Electronics Forum | Tue Nov 22 19:32:27 EST 2011 | kenkay
We are looking for a new machine to replace our Asymtek C-708 that we use for wave masking. Asymtek offers a D-585 but we were looking for something better then a table top unit. Any recommendations on a company or machine? Thanks
Electronics Forum | Thu May 27 13:40:20 EDT 2004 | pjc
The pumps are for a Flux Density Controller FDC550. Contact Speedline Tech.- Electrovert to get a manual. 800-737-8110.
Electronics Forum | Thu May 27 13:18:30 EDT 2004 | swilson
Hello does anyone have a schematic or service manual on setting up a foam fluxer on the 650C wavesolder machine. I am concerned with the two pumps in the rear of the machine what are the connection for on the pumps. I do have the manuals, but they do
