Electronics Forum | Sat Apr 06 10:36:40 EDT 2013 | ericrr
this is on a repair when I add more paste, I am sorry I asked
Electronics Forum | Tue Jan 18 23:28:30 EST 2011 | story108
how can i repair the geared motor.,because most of them was shorted on motor winding.
Electronics Forum | Thu Aug 25 01:30:47 EDT 2016 | souldierann
Hi folks, I hope you can help me on how to repair broken pcb pads.
Electronics Forum | Thu Aug 25 15:53:41 EDT 2016 | davef
IPC-7711B/7721B Rework, Modification and Repair of Electronic Assemblies [http://www.ipc.org/TOC/IPC-7711B-7721B.pdf ] start looking at page xiii. Alternately, try Circuit Repair Center [http://www.circuitrework.com/general/features.shtml ]
Electronics Forum | Thu Jan 20 07:49:06 EST 2011 | cyber_wolf
klaatu barada nikto
Electronics Forum | Thu Aug 25 22:31:51 EDT 2016 | souldierann
thank you davef for this.
Electronics Forum | Wed Jan 19 15:41:10 EST 2011 | jmw
take apart the bad motors....save the good parts.....then order new motors that work......problem solved
Electronics Forum | Sun Jul 15 20:10:09 EDT 2001 | Danial
What is the best method to repair Warped PCBA. Obviuosly twisting it back to make it flat would be a disasterous. The method that I've tried wold be mounting the assembled board to the flat holder with the clamp and bake them at 120 Deg C for about 4
Electronics Forum | Sat May 14 03:56:40 EDT 2005 | Mika
I am interested in RoHS "through-hole soldering": We have a problem with solder wetting and fillet during selective and wave soldering, with a Ni/Au PCBA!! Different fluxes has been tested, but this is really a big issue. Now; there is only a few fl
Electronics Forum | Fri Aug 10 19:49:32 EDT 2001 | nifhail
What would be the best method for attaching the balls, when doing BGA rework. I Found that by using the solder paste, it will give us better rework yield vs using the paste flux ? My data was collected from a very small experiment and hard to conclud
