Electronics Forum | Tue Nov 19 12:34:33 EST 2013 | jimmyboz
I am not trying to be critical but, you didn't even say Fuji CP-6 problem. There are CP-6, CP-642, and CP-643 machines, are asking 2 model as 642? Anyway, slow the cam speed down in the proper to 40 or 50%. If the problem goes away check the mainte
Electronics Forum | Fri May 30 11:58:16 EDT 2008 | fredc
The right paper incorrectly applied can be a problem also. I have seen it on even new Fuji nozzles with the illumination disk bunched up on one side of the tube with a gap on the opposite side.
Electronics Forum | Wed Jun 01 14:58:45 EDT 2016 | claudea2
I answered my own question. The nozzle changer was in the left front, moving it to the left back fixes the problem.
Electronics Forum | Sun Nov 17 10:50:11 EST 2013 | sara_npi
Hi, I have difficulty on solving unknown nozzle st 17.situation goes like this,almost I run bout 6 models each day,but 1 to 2 models only have this problem.I almost done a few basic troubshoot such as clean censor st 17,clean cluch using prope
Electronics Forum | Wed Jun 01 11:02:57 EDT 2016 | claudea2
I have 3 used Quad 4Cs and the nozzle changer on one machine never worked. I decided to troubleshoot it this week. I repaired the changer by changing a defective optical sensor but I still get error 17 when I try a run-step nozzle 1, 2 or 3. Error 17
Electronics Forum | Thu Jan 19 12:38:03 EST 2012 | cobham1
I am wondering if the failurs that people see are discovered right away or when the units are out in the field. Reason I ask this follow up question is the units that are having problems are all returns from our customers. Is there a way to check for
Electronics Forum | Fri Apr 29 19:39:58 EDT 2011 | jbaez1
Hi, have somebody out there experienced problems picking up passive components with flexjet head FJ7P?? Just 1 nozzle-spindle is failing, trying to pickup a resistor,cap or diode; I have already changed nozzle tip, nozzle adaptor including springs,va
Electronics Forum | Thu Nov 30 15:18:54 EST 2000 | Rich Z
All, I have a reoccurring issue with the Alpha-Metals WS601, water-soluble paste in that the size 20 nozzle of the auger-type dispenser on my Camalot Gemini II clogs up rather frequently. Every few hours we are having to go in and clear out the nozz
Electronics Forum | Fri May 13 09:11:01 EDT 2011 | vickt
And does this problem spindle exchange nozzles in the changer without issues? When was the last time the clutches were replaced? thx
Electronics Forum | Fri Jul 29 08:50:30 EDT 2005 | bandjwet
For these type of connectors proper underside board heating, a customized nozzle and careful past printing are the keys to reworking properly. Pls contact BEST Inc at http://www.solder.net offline if you need someone to look at these for you. Regar
winsouce.jpg)
.gif)
