Electronics Forum | Tue Oct 12 13:40:14 EDT 2004 | Jimmy
We recently went through an evaluation period of an NXT modular setup. We ended up purchasing the 2XM6 setup mainly due to the board length limitation of less than 10 inches for the M3 modules without splitting feeders. The machine has been extremel
Electronics Forum | Thu Oct 14 07:45:56 EDT 2004 | Steven
Hi, It is nice with a flexible machine. But what is the cost? It sounds so nice when you see a demonstration or the alike. What I have heard about the NXT model is that if the boards becomes wider than 210mm or so, the performens drops whit about 5
Electronics Forum | Fri Jan 20 04:15:36 EST 2006 | Pana/Fui User
6 month back in China -Panasonic CM402 and Dt401 beat NXT flat in terms of quantity and quality so so. Panasonic used RF CVT system for component verification and E plant view to monitor the production output.They were also able to plot charts and g
Electronics Forum | Fri Oct 08 04:57:30 EDT 2004 | newtoelectronics
I would like to design a small delay timer circuit to activate from a switch that when it is N/O it starts timing for two seconds and then activates a buzzer. I am trying to use a 555 timer with a buzzer attached running from a two lithium 3v batteri
Electronics Forum | Fri Oct 08 08:28:27 EDT 2004 | davef
Wonder Solder [ TRT-Wonder.com ] is a proprietary silver solder. Some cynics might say Wonder Solder got its name because the people that started the firm wondered if anyone was crazy enough to pay that much for solder. Most audiophile silver solde
Electronics Forum | Wed Oct 13 01:12:31 EDT 2004 | saiwong
I think forgot one most important thing. SMT is not all. In China, after the SMT process, QC, QA, casting, packing etc. It need lots of labors. I really one worker can handle 4 lines. Nokia still have two bid factory in China, Motorola has two also.
Electronics Forum | Thu Oct 14 06:27:45 EDT 2004 | davef
a disturbed solder joint. * Extended/slow cool down ramps can result in surface texture => grainy solder joint. Second, the "BGA scaling" could be a reflection of: * Too little heat (incomplete solidification) OR * Too much heat (excess grain growt
Electronics Forum | Thu Oct 21 02:07:06 EDT 2004 | darby
Reprint Services are excellent - even if you did not buy the machine from them. I have had two 100VP machines for 8 years and always go to these guys when I am in trouble. I've never met them and they have never met me but they treat every query with
Electronics Forum | Thu Oct 14 17:14:39 EDT 2004 | mattkehoe
We are experiencing a problem with soldermask defined BGA pads not accepting solder during the reflow process. The paste is there when the boards come off the printer but after reflow, no paste. Some other pads in the same pattern are fine. Here is t
Electronics Forum | Fri Oct 15 09:11:39 EDT 2004 | mattkehoe
Hi Justin, Thanks for the feedback. We are inspecting with the naked eye. Most of what we do are prototype quantities, in this case 6 pcs, so AOI or measurement equipment has never seemed justified. The release looked uniform during the printing a