Electronics Forum | Tue May 25 13:10:17 EDT 2004 | bbarr
I have purchased bellows from Garland. They seem every bit as good as original equipment at a lower price. I am going to try nozzles from them next. http://www.gscusa.net/ Bob
Electronics Forum | Tue May 18 09:40:46 EDT 2004 | russ
Can you have them checked in and out at the beginning and end of each shift? Any missing tools must be paid for by employee, This does make them stick around longer. Of course then you end up with "someone came by and took them" excuses. but it d
Electronics Forum | Tue May 18 17:56:19 EDT 2004 | Glenn
Thanks Dave! I'll see if I can find the standard on IPC's website or inhouse (our company) if I am lucky. I appreciate it. What type of flux are you guys using? No clean? or Water-soluble?
Electronics Forum | Tue May 25 14:20:47 EDT 2004 | spray fluxing
If you are beginning a new evaluation of fluxes, make sure you consider an ultrasonic spray fluxing system with recipricating head. A fluxer from Ultrasonic Systems can add valuable data to your wave solder process
Electronics Forum | Fri May 21 15:04:16 EDT 2004 | davef
Here's a point of view from a friend of SMTnet that's been around the block [erzit beerhall??] so many times his knees creak: http://www.smtinfo.net/dfmce/panelization.pdf
Electronics Forum | Wed May 19 09:52:02 EDT 2004 | davef
No one alive has ever seen a Transit of Venus. It will occur on June 8 2004. Get ready. Look here: http://transitofvenus.org/
Electronics Forum | Wed May 19 12:29:11 EDT 2004 | rob_thomas
I wish I was in an area where the whole thing was visible. I'll just enjoy the pictures I guess. Rob
Electronics Forum | Wed May 19 14:44:53 EDT 2004 | JSK
Low voltage readings on (PSU 2). should be: = is: +12V = 4.3V -12V = 8.6V +24V = 7.6V Anysuggestions? (Other than buying a new card.) Thanks, jsk
Electronics Forum | Wed May 19 16:48:23 EDT 2004 | SWagner
You might have something dragging down your power supply, I have had the color monitor do this when it approachs the end of its life span, I have also had the power supply itself go bad but the voltage is usually 0. Unplug the monitors and see what
Electronics Forum | Thu May 20 16:14:55 EDT 2004 | jsk
UP AND RUNNING!!! Power supply is good but i found two loose wires in connector 12PL26 (DC to Y1). I think i may have another bad connection inside the Y1 enclosure. Monitor seems to be working OK. Thanks for your help, jsk