Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Tue Aug 15 09:40:43 EDT 2006 | SWAG
Not sure about 2020 but AP's have an option to perform a histogram test/adjustment on the lighting. It's a black card, white card test and you can adjust a pot. in the machine to make the histogram curve "best-fit". On an AP, you find this option i
Electronics Forum | Mon Sep 10 10:42:49 EDT 2007 | chrisgriffin
Set "FP" mode to 1 in the setup menu 1. It won't fix your problem, but it might help a little. What kind of board support system are you using?
Electronics Forum | Wed Sep 30 06:31:07 EDT 2015 | mervin
Thanks SWAG, I have checked the FP mode, I am aware of this. I have also worked on this machine some over 10 years ago but not as a service engineer. So I aware of the programming on the machine its just trouble shooting this particular machine is n
Electronics Forum | Wed Sep 30 05:10:28 EDT 2015 | aemery
SWAG does make a good point. The tool he is talking about is located on setup page 1 in the vision box and is labeled FP Mode (Fine Pitch) mode. BY default the setting is "0" this means that once the machine is put into auto mode the camera or visio
Electronics Forum | Wed Sep 30 06:22:23 EDT 2015 | mervin
MPMENG, Thank you so much for taking the time to help. The machine has Y snuggers and flippers. The Pcb is loading in the center all the time. The driver cards look fine there is no obvious faults on them or partially burned. The machine was not in
Electronics Forum | Mon Feb 27 13:33:03 EST 2006 | Robert
Our MPM 2000 screen printer machine has a problem. During the machine reset mode a warning message come up "Z lockout not operating". Does anyone know what fault could cause this?
Electronics Forum | Tue Jun 19 08:43:47 EDT 2007 | leemeyer
Does anyone know the default password to enter the supervisor mode on an MPM SPM screen printer. I recently had a disk drive crash and had to reload the software. Thanks
Electronics Forum | Mon Sep 10 11:00:11 EDT 2007 | mgrimes
Chris, Appreciate the response - we set FP to "1" last week but no help. The drift is only in the X as well - the Y is never off. We have tried switching the cards to see if if the problem goes to the Y but it doesn't - stays in the X. As for the b
Electronics Forum | Wed Apr 24 13:49:19 EDT 2019 | griinder
I have a support question concerning setting the gridlock tooling in manual mode on a MPM Momentum Elite. I am printing the top side (bottom is populated with parts) of a thin, flimsy PCB. The Grid lock tooling bows the PCB upwards in Auto mode, beca
winsouce.jpg)
