Electronics Forum | Mon May 02 14:59:26 EDT 2005 | Linda Woody
Has anyone experienced electrical shorting between adjacent leads of a ceramic hermatic sealed IC? If so, can you share root cause and corrective action? The shorting appears to be in the glass frit seal itself but the failure mechanism is unknown. A
Electronics Forum | Tue May 03 21:49:45 EDT 2005 | KEN
Tin wiskers Electro migration all in the same week! (just kill me now God)
Electronics Forum | Fri May 06 10:38:28 EDT 2005 | jimby
Make sure that whoever is pretinning leads are not using a water soluble flux. If they are, make sure parts are being cleaned immediately upon cooling
Electronics Forum | Thu May 25 03:31:17 EDT 2006 | slaine
Hi I manufacture ceramic parts that have a terminations that are palladium/platinum/silver or any combination of the 3. Termination Ink usually consists of 3 main parts the alloy, glass frit and binder. Binder is to help bind everything together whi
Electronics Forum | Tue Jan 30 21:15:51 EST 2001 | davef
You seem to pretty far from shore to begin thinking about boats and floatation devices. Most laser trimmers are used by: * Semiconductor fabricators * Resistive component fabricators * Hybrid circuit assemblers Component fabricators and hybrid [
Electronics Forum | Fri Jun 30 06:07:12 EDT 2006 | slaine
Hi If all the solder has collected onto the component termination then it sounds more of a PCB problem then a component problem. Some times all the temination can be stripped off the ceramic with high tin content solders and leave a gray finish behi
Electronics Forum | Thu Aug 07 10:02:10 EDT 2008 | eyalg
We are facing low quality due to soldering opens with coilcraft inductors 0402CS-2N7XGLW. The termination used is(suffix L =RoHS compliant silver-palladium-platinum-glass frit. Did anyone had this problem in the past? Can we do better using T = RoH
Electronics Forum | Tue Jan 05 19:25:50 EST 1999 | Earl Moon
| Jan 05, 1999 | | My question is: | Pls kindly advise what is the meant by a "Think Film hybrid design" and what are the advantages it would have on surface mount passive components e.g. capacitors and reisitors?? | | Thanks for your respond. | El
Electronics Forum | Wed Feb 25 08:34:00 EST 1998 | Earl Moon
CERAMIC CIRCUITRY Starting with hybrid thick film circuits in 1965 at Sperry Flight Systems, I have been involved with ceramics (usually aluminum oxide) as the substrate material. Then, we developed "multilayer" circuitry (replacing "cordwood" module
Electronics Forum | Wed Feb 25 08:30:44 EST 1998 | Earl Moon
| Happy Holidays All, | I am searching out a vendor (US preferred) who can fabricate a ceramic PCb with etremely fine lines. | Please reply if you are a vendor, or know of one. | Thanks, | Wendy CERAMIC CIRCUITRY Starting with hybrid thick film circ
1 |