Electronics Forum | Thu Oct 02 01:59:06 EDT 2008 | edmaya33
Obviously nobody can help you Jack. 1. its the camera for parts recognition ( enhanced CMOS ). 2. positioning system upgraded from ball screw to linear motor/gantry. before CPH=16500 new CPH=18000 using H12S
Electronics Forum | Wed Apr 13 15:34:27 EDT 2011 | wingding
I am looking for a FUJI CP3 Y Ball Screw. P/N: W1505-29P-C5Z10. I have contacted ibe, SMT Research, and SMT Parts. FUJI has one but it is $3,000 dollars, in the end $3,000 may be a deal. But for now I'm still looking. Any assistance would be greatly
Electronics Forum | Mon Apr 18 09:22:53 EDT 2011 | cyber_wolf
If it's an NSK screw try giving them a call. Have your calipers ready.
Electronics Forum | Thu Feb 22 00:22:53 EST 2007 | J. Pigott
I realize this is a bit off topic but looking at some of the discussion. I expect someone might be able to help. Looking at CP IV ball screws 120" and searched the world over for specs. Lead Outer Diameter TPI backlash resolution typical wear on c
Electronics Forum | Wed Feb 24 11:36:06 EST 2010 | kruzon
Is there a simple way to create vision data for bga's. Our machine is a Fuji IP3. I have a bga with balls all over the place. Thanks -
Electronics Forum | Wed Dec 20 07:08:51 EST 2006 | cyber_wolf
We have had this happen. The Z-ball screws do go bad in IP3's. We replaced the ball screw and the problem went away. As mentioned improper belt tension will cause the servo to make loud noises. But if you say the movement is rough, then the ball scr
Electronics Forum | Sat May 29 15:55:04 EDT 1999 | M Cox
| Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according to a F
Electronics Forum | Fri Feb 12 14:06:28 EST 1999 | Craig Lowe
Bill, I would go with the second piece of advice by leaving a little film of solder paste on the screen. This is good advise if you are using a lookup/look down type of vision centering. Like on MPM and newer Fuji. On older Fuji GSP2/3 style printer
Electronics Forum | Mon Aug 27 22:48:21 EDT 2001 | dougk
Used an older model of the one you described. Have used Asymtech and Fuji's as well. The Camalot is accurate, reliable, and easy to program. The only things I disliked about it was that is was slower than the fuji's, and if the pressures weren't set
Electronics Forum | Fri Jan 17 11:21:45 EST 2014 | mi
Hi, Flexa is a NEW SW TOOL that Surya purchased for SMT assembly. (Surya has had experience with GC-PLACE but limited only for Mydata machines SMT placement.) Flexa is good for Fuji machine. My question was configuring this SW TOOL's connection set
