Electronics Forum | Wed Jan 31 13:00:43 EST 2007 | bvdb
The continuing saga - we got the IP-1 communicating with the MCS16 again by replacing a couple of chips on the VME1152 CPU board and now it's working again but have a new problem. The machine stops about every other time when changing nozzles with a
Electronics Forum | Thu Feb 01 02:36:40 EST 2007 | bvdb
Hi pr, The problem was happening on all three of the nozzles that we were using, about half the time the Z axis would rise up and go for the next nozzle and the other half it would stop almost as soon as it released the nozzle. When I inch the Z ax
Electronics Forum | Wed Jan 31 14:58:13 EST 2007 | pr
Is it the same nozzle every time? I would check that the shaft is hitting dead center (it could be binding)on the nozzles (especially if it only happens on 1 nozzle). Also check the rollers on the shaft (that hold the nozzle) and make sure they line
Electronics Forum | Tue Jun 23 06:01:24 EDT 2009 | brucow
Hi All, The x-axis ballscrew on the x-y table of our Fuji CP642 is getting very noisy. Could someone in the know please run me through the procedure for changing the ballscrew and will any calibration be required after fitting? Any help much apprec
Electronics Forum | Mon Apr 21 10:34:39 EDT 2014 | cyber_wolf
I think we traced it down to the sensor on the x-axis motor.
Electronics Forum | Tue Mar 17 16:56:45 EDT 2009 | gregf912
Sorry Keith but is not possible to place 0201 parts on the CP43 machine. THe XY table is not tight enough on the resolution or the Z height. The parts camera will not be able to tell the part from the nozzle. THe CP6-4000 machine can not do 0201 part
Electronics Forum | Wed Jun 29 19:33:12 EDT 2005 | matjen
After the machine stops for any reason when restarted the z table goes to loader position comes up then goes back down and re-reads the fiducials, only one machine does this but we are losing valuable cycle time after every part change. We have Fuji
Electronics Forum | Mon Feb 08 18:14:55 EST 2021 | cyber_wolf
If I am not mistaken, a CP65 has different windmills and is slower. Has Open feeder axis like you said so it makes more noise.There could be more... If you love CP642's message me. I have (2) that are coming out of service along with a bunch of spar
Electronics Forum | Sun Jul 10 13:24:48 EDT 2011 | sarason
I have finally updated my shareware SMT Machine program It reads Protel ( from Autotrax to Altium Designer) and spits out Yamaha/Philips UFOS, VIOS , Mydata, Fuji MCS2 CP642 CP732, Gencad 1.3, Philips, FCM, ACM, FTIP, Essemtec, Panasonic BM221 CM88,
Electronics Forum | Wed Jun 23 10:05:17 EDT 2004 | exmaintenanceleader
Hi Grant, I'm ex Fuji service engineer I install also at Sagem Czecz Republik (Kladnow near Prague) in 2000 they use at new lines MPM- 2XCP643E and 1xUniversal GSM (French owen (I do not remember the exacly tipe) at second hand line they use 2x and
winsouce.jpg)
