Electronics Forum | Wed Feb 17 13:15:51 EST 2010 | jdengler
It turned out to be the battery in the CP-1 PLC. Replaced the battery and we are back up and running.
Electronics Forum | Sun Aug 30 15:32:33 EDT 2009 | jimmyboz
most fuji error codes are 8 digits, A21E is 2100A21E, it is a report from the MCS that transmission has failed (we knew that) Hit control E from the main screen of the MCS, there should be another error reported from the cp6, ie. 1101000 is x data ou
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Sun Aug 18 21:06:45 EDT 2019 | dman97
Based on the fuji error codes, It says that the ARCNET cable is disconnected. Make sure that all cables from this module are connected to the QP.
Electronics Forum | Fri Apr 23 02:15:36 EDT 2010 | smellew
Hi Rodrigo, Have you fixed your CP65? do you need some help? llew
Electronics Forum | Fri Jul 07 17:33:25 EDT 2023 | jdengler
Since you haven't received any useful advise I will throw my 2 cents in. I do not know this machine but in general what you describe is an axis that does not get it's home pulse in time. Many machines will have an in-range sensor that gets flagged
Electronics Forum | Fri Apr 16 17:44:40 EDT 2010 | rodrigo
We're still trying to fix a C-axis overflow error in our CP-65. I was swapping servo boards and one of them started to blinks a 2 on the LED single digit display and the machine didn't boot up. I replaced the servo board with a spare we bought on eba
Electronics Forum | Sat Nov 07 18:38:32 EST 2020 | enzik
Hello to all, The Fuji GSP III screen printer was working well yesterday. This morning, the machine turned on and the display screen was showing nothing. I went to the back of the machine and reset one of the VM1152A. The display screen is now showi
Electronics Forum | Fri Mar 02 14:00:39 EST 2018 | magergar
I have a problem with my fuji machine, it was working and then this error code appear: INTL SRV creation error Error Code:12037A20 and this shows every time on boot and doesn't let me do anything. what should I check?
Electronics Forum | Tue Jul 15 17:52:30 EDT 2003 | samaniegocesar
I found the problem. The CPU is damaged I change the cards and it works.. Thanks and best Regards...
