Electronics Forum | Tue Nov 21 13:45:07 EST 2006 | fujillews
Asymtech glue machine would do the job..different heads are available. Fuji GL series machines are also good but require a offline controller Even with PTH components Screen printing glue is still possible,some call it pump printing? what type of pl
Electronics Forum | Tue Dec 19 07:16:56 EST 2006 | Nuno
There is many Bond dispenser that have the Option to check the area & adjust in case of NG area . You just make the value of area & interval for check and correct . The Ones that I know is Panasonic HDF (great Output 0.07 tact time ) And Fuji GL5 ser
Electronics Forum | Sat Jul 25 04:48:40 EDT 1998 | Stoney Tsai
Hi, good friends I found this site is so wonderful to learn SMT techniques meaningfully. We now employ 3 Fuji GL-541 dispensors and raw material with Soma IR-120. but we found glue string casually. From my experience from trouble-shooting the cabinet
Electronics Forum | Wed Jul 29 17:43:26 EDT 1998 | Steve A
| Hi, good friends | I found this site is so wonderful to learn SMT techniques meaningfully. | We now employ 3 Fuji GL-541 dispensors and raw material with Soma IR-120. but we found glue string casually. From my experience from trouble-shooting the c
Electronics Forum | Sat Feb 19 06:56:56 EST 2022 | nikevoo1
Glue dispenser Fuji GL-V should have PASS and PRODUCT mods. But the PRODUCT mode its gone. There is only PASS mode and we cant change it. I tryed to replace the CPU board but the problem stayed. Any ideas?
Electronics Forum | Wed Jul 11 14:08:21 EDT 2001 | markhoch
Are you guys providing adequate board support during glue dispense and placement? I've had this same problem with 0603's that I was able to correct with adequate board support. Also, if you're using a Fuji glue machine, what are your temperature sett
Electronics Forum | Tue May 09 10:14:08 EDT 2000 | Stuart Hockensmith
hello- I am looking to add into my predominatly Fuji SMT lines a glue dispensing machine. I currently have for dispensing technology is a Camalot 3800 in one of my two lines. The second doesn't have any capability for glue , thus the reason for
Electronics Forum | Sun Apr 09 14:20:17 EDT 2006 | greatexpectations
Hi, This setup was recommended. Target is 20,000 board output per day FUJI GL-541 Glue Dispenser (USED) 32K FUJI GL 641 SCREEN PRINTER (USED) 57K CP-643E CHIP SHOOTER 255K (150 FEEDERS) FUJI QP-242E IP3 110K REFLOW 8 ZONE (IS THIS ANY GOOD) 4
Electronics Forum | Fri Jul 27 13:16:03 EDT 2001 | cjrjmj
I am looking at the Pump application for several bottom side applications we have. They are heavy in through hole radial and dip content. The initial testing of the stencil was very good, but I am concerned with inspection of the glue. We do a sampli
Electronics Forum | Mon Jul 27 08:42:13 EDT 1998 | Justin Medernach
| Hi, good friends | I found this site is so wonderful to learn SMT techniques meaningfully. | We now employ 3 Fuji GL-541 dispensors and raw material with Soma IR-120. but we found glue string casually. From my experience from trouble-shooting the c
