Electronics Forum | Thu Oct 29 23:49:32 EST 1998 | Thomas Clift
I am currently in the process of rebuilding and maintaining a never-ending supply of tape-feeders for Fuji CPIII and IPII (Fuji and Hover-Davis). I have seen the videos and am not having all that much trouble, but I would like to compare notes with s
Electronics Forum | Fri Oct 30 18:51:07 EST 1998 | phillip hunter
| I am currently in the process of rebuilding and maintaining a never-ending supply of tape-feeders for Fuji CPIII and IPII (Fuji and Hover-Davis). I have seen the videos and am not having all that much trouble, but I would like to compare notes with
Electronics Forum | Mon Aug 25 11:43:30 EDT 2014 | fuji_user_2014
Looking for information on how to stop our Fuji from picking up parts in advance for the next board at the in carrier. In other words, how can we stop the machine from picking up parts before reading fiducials on a board without adding a skip mark t
Electronics Forum | Thu Jan 18 14:03:09 EST 2007 | pima
Hello everybody!! I would like to know what kind of tool do you use to analize pick-up error rate at CP and IP fuji machines? Is it special kind of software or you use some customized solutions? Im thinking about writing some kind of database based
Electronics Forum | Wed Aug 27 16:08:51 EDT 2014 | fuji_user_2014
Alright, thanks for the fast reply
Electronics Forum | Wed Aug 27 13:49:02 EDT 2014 | jimmyboz
In that case, please consider one block skip mark, the same first sequence for all programs, view some feature of the X-Y table, not the PCB, that way, its just a habit. I will look into preventing advance pick, not sure if it is possible.
Electronics Forum | Tue Aug 26 09:13:34 EDT 2014 | fuji_user_2014
Thank you, but as I said before, is there a way to do this WITHOUT adding skip marks? We need a global setting that will affect all our existing programs.
Electronics Forum | Wed Aug 27 13:59:10 EDT 2014 | jimmyboz
Or else, as Dman may have been pointing to, duplicate the first fid sequence, and use it as the block skip mark, if found, then the next sequence is the fid it already found as a block skip mark....
Electronics Forum | Mon Oct 03 13:37:40 EDT 2016 | chabscan
I've been having some problems with my Quad 4C, it rejects some components after having pikced them up. I want to adjust the tolerances and test the pick up. I want to know if there is some way of testing the pick up without having to run my whole
Electronics Forum | Mon Aug 25 16:14:59 EDT 2014 | dman97
In Fuji flexa, under the machine configuration tab. Panel and Board mark reading order should be set to SKIP MARK. (this only works if you have the skip mark active in your fiducial list)If it is set to FIDUCIAL MARK, then the machine will ALWAYS pic
