Electronics Forum | Tue Feb 15 10:38:30 EST 2005 | Dougs
I've seen this before. I had a CP6 doing this for a while, replaced the nozzle springs with ones wound the opposite way from the fuji ones. replaced the springs with these and never had the problem again. you can get them from Ritchie precision eng
Electronics Forum | Tue Nov 25 10:44:00 EST 2003 | cyber_wolf
The clutch return spring ?
Electronics Forum | Tue Dec 02 03:58:11 EST 2003 | ex maintain leader
Sr. Tech, try to find a private spring manufacturer locate in your aera. The asian springs are not long life, no heating schock is done during manufacturing. Panasert and Fuji feeders usual problem each factory I visited. This is a way for you to re
Electronics Forum | Thu Jun 15 08:44:18 EDT 2006 | jdengler
Bert, The original IP feeders do a poor job of peeling the cover tape. Things to check: -All teeth present on the take-up reel -Take-up reel has even drag as it rotates (reel out of round or dirty) -Take-up reel drag is not too high (locations and
Electronics Forum | Mon Mar 07 18:41:13 EST 2005 | jimmyb
--IE, Funny.--- I "remember" kinda, from the early CP6 years, things about the springs. The early Fuji springs had sharp ends, and if you spun the nozzle, prior to final attachment, the opposite way it could stick, and if it was spun the right way,
Electronics Forum | Tue Nov 25 10:40:42 EST 2003 | Fuji_Dude
Try putting on new springs on the feeders. This a common and frustrating problem with CP6/7 feeders.
Electronics Forum | Tue Nov 25 10:40:50 EST 2003 | Fuji_Dude
Try putting on new springs on the feeders. This a common and frustrating problem with CP6/7 feeders.
Electronics Forum | Thu Mar 03 11:10:20 EST 2005 | Dougs
I'm telling you i've bought the nozzles wound the wrong way and it helped, no more probs with nozzles sticking, i'd tried buying fuji nozzles, checked all my component heights, set Z0 properly, checked shaft heights, set up st1, etc etc but the new s
Electronics Forum | Sun Mar 21 22:03:35 EST 1999 | Nick
It looks like your holders now require some maintenance. You will need to throughly clean all the holders of all dirt debris and then relube the holder lightly with T&D or grease. You will only need to lube the shaft of the nozzle change enagager an
Electronics Forum | Thu Jun 24 20:14:52 EDT 2004 | Alan
I know your frustration. CP6 feeders are notorious for this issue. They have always been an issue. You have probably went through the "change spring, change tape leaf, change component reel, place peeler tape over two rollers instead of three" scenar
winsouce.jpg)
