Electronics Forum | Thu Oct 02 01:59:06 EDT 2008 | edmaya33
Obviously nobody can help you Jack. 1. its the camera for parts recognition ( enhanced CMOS ). 2. positioning system upgraded from ball screw to linear motor/gantry. before CPH=16500 new CPH=18000 using H12S
Electronics Forum | Wed Jun 29 03:23:10 EDT 2005 | dougs
We used to use a company in the uk that did this, we stopped as the results were never that good, i think the company stopped offering the service as well as no-one else wanted to have their nozzles repaired, it's best to get new nozzles in and make
Electronics Forum | Fri Oct 30 18:47:19 EST 1998 | phillip hunter
| Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? | | I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 1
Electronics Forum | Wed Jun 29 19:33:12 EDT 2005 | matjen
After the machine stops for any reason when restarted the z table goes to loader position comes up then goes back down and re-reads the fiducials, only one machine does this but we are losing valuable cycle time after every part change. We have Fuji
Electronics Forum | Thu Jun 11 06:57:22 EDT 2015 | cyber_wolf
Linux, The amount of error that you are describing is about the thickness of a human hair. Unless you are placing 0201's I can't understand why .12 is an issue. There are many factors that can effect placement accuracy on a CP6 For instance: 1. M
Electronics Forum | Tue Jun 13 14:52:12 EDT 2000 | Jason
Dear Mr. Fields, SMT Parts, USA (San Jose, CA) supplies the light dispertion disk for the CP6 nozzles. Call Mr. David Lombard at 1-831-477-1518 Hope this helps. Jason Robotham Tekmart
Electronics Forum | Tue Nov 19 12:34:33 EST 2013 | jimmyboz
I am not trying to be critical but, you didn't even say Fuji CP-6 problem. There are CP-6, CP-642, and CP-643 machines, are asking 2 model as 642? Anyway, slow the cam speed down in the proper to 40 or 50%. If the problem goes away check the mainte
Electronics Forum | Fri May 30 09:50:04 EDT 2008 | jdengler
Another sticky issue is that if you use after market nozzles especially mixed in with Fuji nozzles the Anti-Marking Illumination Disks can be different enough that the vision system will reject nozzles. Jerry
Electronics Forum | Fri May 30 09:53:19 EDT 2008 | cyber_wolf
"Another sticky issue is that if you use after market nozzles especially mixed in with Fuji nozzles the Anti-Marking Illumination Disks can be different enough that the vision system will reject nozzles. Jerry " Thats what I meant when I said they
Electronics Forum | Fri May 30 11:58:16 EDT 2008 | fredc
The right paper incorrectly applied can be a problem also. I have seen it on even new Fuji nozzles with the illumination disk bunched up on one side of the tube with a gap on the opposite side.
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
3 Road Xintang, Fuhai Street,Fuyong
Shenzhen, 30 China
Phone: 13713862102