Electronics Forum | Tue May 03 07:54:40 EDT 2005 | scotceltic
Does anyone have any contact info. for affordable custom tube feeder setup for a FUJI QP3 Machine ?? I have already tried Component Express. Although their application would work it is just too big for us.
Electronics Forum | Tue Dec 16 11:41:26 EST 2008 | fredc
I think fuji and all the after market suppliers use stainless "hypo" tubing for the tips. It is made from 304 stainless which is normally nonmagnetic. In the process of forming this tubing to the hypo specs it is work hardened to 3/4 to full hardness
Electronics Forum | Fri May 30 11:58:16 EDT 2008 | fredc
The right paper incorrectly applied can be a problem also. I have seen it on even new Fuji nozzles with the illumination disk bunched up on one side of the tube with a gap on the opposite side.
Electronics Forum | Mon Jul 03 23:29:26 EDT 2006 | grantp
Hi, Don't know about your machines, but our XP Fuji machines have a lubrication tube linking the under side of the machine to the top, so you can put a grease gun on it, and push grease into hard to reach places. Does yours have that? If your heari
Electronics Forum | Mon Jan 31 15:02:52 EST 2005 | gs
First of all ask your Suplliers to provide you SMD in Tape & reel, second point, you can ask Service for Tape & Reel or in case components are not so many, you could asses ef convenient to buy a sinple maual Tape & Ree machine and do it inside your f
Electronics Forum | Thu Jan 31 09:07:25 EST 2008 | aj
Hi, we have the same problem here but have a solution. We have Fuji FIP3 machines but this should be the same for all - use the tube that the parts are in for part presentation ! i.e. cut out a window big enough at the top of the tube for the nozzl
Electronics Forum | Thu Apr 29 07:47:18 EDT 2004 | bravoone
Ok sorry for the 'simpleton' question, we have a Fuji IP4000 with loads of normal 'roll' feeders and a MTU, we are having more and more supplies of chips in 'tubes'. I see in the manual there is a mention to 'stick feeders'. Does anybody use these? D
Electronics Forum | Wed Oct 10 09:42:02 EDT 2007 | fredc
Hello Sr.Tech, There have been two types of nozzles made by Fuji for 0201's one was a 1mm tapered to .4mm and the other has a straight .4mm tube. Has one superceded the other and if you have used both types, did one work better than the other? Asking
Electronics Forum | Thu Oct 30 09:23:34 EDT 2008 | jwolvans
Hi, Rob. Does the table appear to hang up, then suddenly let go? If so, check the alignment of all four conveyor rail guide blocks, especially if the clamping rails have been recently removed for maintenance. After that, check the piston assembly t
Electronics Forum | Thu Feb 05 08:27:58 EST 2004 | pjc
We had a V-Tek TM30 manual taping machine using heat seal top tape. Had very good results- with skilled operator - to supply taped components to our 2x Fuji IP2 machines - no tape cropping. Stefan's points are somewhat valid, but you can have a succe
winsouce.jpg)
