Electronics Forum | Wed Oct 29 18:08:35 EDT 2014 | tombstonesmt
Good afternoon. Not sure if this is available at an engineer level. Perhaps and SD card with field service access is necessary. We have two lines with NPM-W's and the most we've been able to do is actuate vacuum on the heads during flow checks.
Electronics Forum | Fri Feb 14 14:09:06 EST 2014 | marcpeo
In general the chains don't need to be heated to 400 deg C for cleaning. In other words, most of the fluxes and constituents in the paste don't collect on the chain and gum it up. Bottom line: the heat treatment is not needed for 95% of the users.
Electronics Forum | Wed Dec 04 15:00:15 EST 2002 | ksfacinelli
I am interested in looking at options for machince calibration and maintenance from a third party provider. The company would have to be up on the servicing of the GEM line of Philips equipment (Emerald / Topaz). Any recommendations??? Kevin
Electronics Forum | Thu Mar 28 20:06:53 EDT 2024 | cbeneat
What type head is it? Try changing the internal filters. If it is a low number head, ie: 1-4 on an 8, 1-6 on a 12 or 1-8 on a 16. These can be accessed by pushing the head to the opposite table for removal. Chapter 11, section 11-6 page 11-6.3 in mai
Electronics Forum | Tue Feb 05 13:56:44 EST 2019 | scotceltic
Hello, looking to see if anyone has any contacts in China (preferably Shanghai area). Looking for a company to quote, recommend and install a full SMT line based on our companies specs. A full service integrator is basically what I am looking for ?
Electronics Forum | Tue Feb 20 21:19:54 EST 2007 | vshan
Hi Mario Good Day!!! in this market you can get machine which suits your capacity but the key points are 1) do you have engineers in the line working together with maintenance group as well as with machine operators. 2) do you have standby spare par
Electronics Forum | Fri Mar 01 03:57:10 EST 2013 | jlawson
Another software vendor that you might want to look at is mentor valor mss tools. System has good mydata support from full programing, grouping and even autogeneration of smt parts, materials management , manual assembly,documents, and many other sco
Electronics Forum | Wed May 17 11:32:23 EDT 2017 | emeto
Tsvetan, This is similar to give an accounting project on a process engineer. Installation and training are usually covered in the deal. Now Anthony is dealing with post factum issues inherited from the person who already did the new line introducti
Electronics Forum | Mon Feb 19 12:18:36 EST 2007 | Hussman
I think you kind of answered your own question. If your maintenance is so bad that your line goes down, or you cannot afford to have downtime, you should be mainly concerned on a P&P comapany that can stand behind you and give you immediate response
Electronics Forum | Tue Jun 26 07:15:06 EDT 2007 | zanolli
I've used PVC, black iron and copper: Forget PVC, too dangerous as joint strength completely reliant on glue, black iron will rust and accumulate debris over time, copper is the best but now because of very high Cu commodity prices could very well be