Electronics Forum | Mon May 30 20:17:54 EDT 2016 | jasltd
Hi Folks, I'm having issues with our dek Galaxy which is randomly having and reporting the error CAN Node Not Responding. Has anyone seen / fixed this error before?
Electronics Forum | Tue Jun 12 17:12:20 EDT 2018 | paul_bmc
I have an issue on my DEK Galaxy printer. The problem is I need to use the hard PCB stop rather than the sensor stop. The printer use to have Heavy Pallet Rails installed prior to me purchasing the machine. The 3rd party removed the rails and repl
Electronics Forum | Wed Jun 01 22:42:50 EDT 2016 | dinhhuunam
CAN Node Not Responding This problem can be caused by either: 1. Faulty Node 2. CAN bus cable disconnected. 3. No power to CAN Node.
Electronics Forum | Thu Jun 02 08:45:41 EDT 2016 | emeto
If it is intermittent it is definitely cable or connector. Check all connections first and if not, replace the cable that is moving/bending.
Electronics Forum | Thu Nov 23 16:42:44 EST 2017 | emanuel
Anyone who uses a DEK Europa can share some information please? Known problems, availability of parts, overall experience or how it compares with other DEK models made between 2004 to 2008... Horizon, Galaxy, etc. We consider purchasing one to replac
Electronics Forum | Wed Oct 04 12:26:36 EDT 2000 | Ashok Dhawan
Not to offend anyone - as this message is not a technical question. I am looking for spare parts for Soltec Wave Soldering Machine Model 6527 Galaxy I. Can anyone advise on sources to get " Used Equipments or spares " ? I need CPU 942/943 Card and
Electronics Forum | Thu Jun 28 09:40:49 EDT 2012 | austinpeterman
We just stepped into the inline wash world with a techical devices new clean galaxy plus. We are noticing a significant amount of foaming when washing our boards after selective solder. One theory is that the water soluble flux used is not being cu
Electronics Forum | Thu Jun 02 04:20:58 EDT 2016 | jasltd
Thanks, I have managed to get a step further and now get the additional info on the error that it is node 1. All cables are connected, will double check the power but I believe it has power, I seem to be able to drive everything in diagnostics mode
Electronics Forum | Tue Jun 12 20:54:34 EDT 2018 | dekhead
I don't recall a "Heavy Pallet Rails" option in software; I believe you need to change the Remote Board Stop to "Not Fitted" and move the pneumatic and electrical (BSK6)connections to correspond with the camera mounted board stop. Pretty well detaile
Electronics Forum | Fri Aug 24 12:42:05 EDT 2012 | kahrpr
a long time ago in a galaxy far far away. we had a requirement for a specific part. We stored it in a room in a plastic container on a wooden shelf and had to rent a Gauss meter and walk around and take measurements to prove that it was anti magnetic
