Electronics Forum | Thu Sep 23 11:37:43 EDT 2010 | flipit
I had 4 of these machines. They are good machines but I have seen this error often. Is the problem only on one head L or R? If so swap electronics L to R and see if it follows. You can even swap the Y motors. The items that could cause this prob
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Mon Jun 12 23:52:58 EDT 2017 | aemery
Don, either you have a faulty park sensor or much more likely the vision gantry Y axis is not reaching the sensor. Possible issues, one of the two VY drivers cards is failing; one of the VY forcer motors (air bearings) is failing; to much air leakin
Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Sun Apr 17 18:22:18 EDT 2022 | dekhead
Please clarify what you mean by "bouncing". Small up and down motions around home position? Full stroke of table movement up and down? Or somewhere in between? Does it start as soon as servo power is applied? Or not until table home movement is initi
Electronics Forum | Sat Oct 24 10:41:40 EDT 2020 | phomann
Hi, This error popped up while running a panel through the machine. I put the machine into the Drift adjust mode and the y axis was drifting, but not smoothly like the X-Axis was. The Y-axis was drifting but not smoothly. It was more of a jerking mot
Electronics Forum | Fri Mar 29 16:57:07 EDT 2013 | aemery
Gentlemen, Just became a member and scanning the old posts hoping to help people out with their MPM printers. Most of this info is correct, the last post was the best. Offsets on an Accuflex printer can be put in either per process program or glob
Electronics Forum | Thu Mar 24 23:34:55 EDT 2022 | glasscake
My Koh Young 3030VAL errors on the homing routine. The "DTool" "MCS" gives me an error "Before homing, X-AAxis already checked negative limit..." "Before Hoking, Y Axis already checked negative limit..." "Please turn off the control-power-switch, an
1 |