Electronics Forum | Mon Oct 25 05:52:34 EDT 2010 | sachu_70
In csae you use 2 fiducial recognition, ensure that board fiducials are oriented across a diagonal and spaced far apart. Also, maintain a prefered dia between 1-2 mm for the fiducial on board to have have a better correction factor recorded during fi
Electronics Forum | Wed Nov 03 20:02:44 EST 1999 | Anthony Winston
Well John here is the situation: I need to place an infrared transistor (optical element) with a tolerance of +/-.003", this is not a problem. A lens is positioned over the optical element and snapped to the PCB via three holes that have a toleran
Electronics Forum | Wed Mar 02 06:19:03 EST 2005 | pjc
Go to http://www.ipc.org and look up IPC-7351 - Generic Requirements for Surface Mount Land Pattern and Design Standard The successor to the IPC-SM-782A is here! The document covers land pattern design for all types of passive and active components
Electronics Forum | Thu Mar 10 09:13:15 EST 2005 | davef
From http://www.IPC.org ... IPC-7351 - Generic Requirements for Surface Mount Land Pattern and Design Standard The successor to the IPC-SM-782A is here! The document covers land pattern design for all types of passive and active components, includ
Electronics Forum | Sat Nov 26 00:02:17 EST 2011 | kevintough
I agree with this post about new and standard component names. Standard components should not be changed outside of perhaps widening the tolerance to accept poorly produced components. By purchasing poor quality/cheep components your purchasing depar
Electronics Forum | Sun Mar 07 13:10:15 EST 1999 | Sam Sangani
| Has anyone used the mechanical stencil foil tensioning system from certain company that eliminates using stencil frames and epoxy & mesh? Any comments on whether it's worth looking into? We go through product revisions like we go through clean so
| 1 |
winsouce.jpg)