Electronics Forum | Sun Aug 08 11:15:32 EDT 1999 | Earl Moon
| | Mike, | | | | Got your message and those of others concerning PCB fab supplier evaluation and qualification check lists, etc. I have a severe problem here in WI as I can hardly access the internet, and when I do it is cut off abruptly for no goo
Electronics Forum | Sun Sep 22 13:14:56 EDT 2002 | scottefiske
Stop the lines...! Stop building defects and rework into your product. Contact Fab Supplier and have pipeline filled for small amount of replacement fabs to keep lines running and limiting production scheduling and impact. Request to have the board
Electronics Forum | Wed Jul 05 17:06:36 EDT 2000 | Michael Parker
Patrick- You have not given enought detail of the type of discoloration. Is it "white residue"? Can it be "rust" colored? Whatever it is, you fab supplier needs to be called in immediately and give you an exact reason for this failure. Just rubbing
Electronics Forum | Wed Mar 16 06:46:59 EST 2005 | -=Verm=-
Hi lads long time no post... I have an issue with a PCB, its a PCI card that we manufacture for a customer of ours. The customer is seeing a problem with contact on a PCI card with the motherboard, the PCI card is removed from the board wiped and th
Electronics Forum | Fri May 10 01:41:04 EDT 2002 | ianchan
Steve, Hi mate, was doing some text book reading and saw this one paragraph that commented on the PCB fab plating could have residue chemistry inherent in the PCB if the fab process control isn't up to mark. such chemistry could surface to the Au/N
Electronics Forum | Thu Jul 02 15:23:15 EDT 1998 | Justin Medernach
| | I'm having a problem getting good reflow on gold sufaced boards. The profile looks good and I have adjusted it both hotter and colder and adjusted the various times ( soak, reflow ) to no avail. What realy gets me Is that a month ago we built som
Electronics Forum | Fri Apr 29 14:16:16 EDT 2011 | ppcbs
Below is the long explanation. This defect is most commonly found with BGA components, but can arrise with all components. I see it happening more now with lead free boards that are being assembled with a no clean flux. Best short term remedy is t
Electronics Forum | Tue May 26 20:18:09 EDT 1998 | Justin Medernach
| | | | I'm reviewing my board fab spec. It calls for a minimum SnPb thickness of 50 microinches on HASL PWB's. I've looked at other specs that call out anything from 30 to 80 microinches, and others that just say the copper pad must be covered and
Electronics Forum | Fri Aug 29 09:39:08 EDT 2014 | rgduval
I'll try to deal with the issues as you've presented them. 1. Blistering/delamination, shown in photo 2. The most likely cause of blistering/delamination like this is moisture in the boards. The moisture can get into the boards in multiple ways..
Electronics Forum | Tue Oct 26 13:53:16 EDT 1999 | Dave F
William: In answer to your questions: 1 "What do I do about a gold porosity problem?" Get it fixed, before you go out of business!!! You�ve been yapping about it on the internet for three days now!!! Get a more on!!! I don�t understand your com