Electronics Forum | Tue Jul 18 10:08:19 EDT 2006 | pms
kapton tape the gold fingers before reflow.........
Electronics Forum | Fri Apr 13 22:38:19 EDT 2001 | edylc
Hi , Could you be seeing the nickel under the gold plating because you are removing some of the Gold with the Kapton Tape....?? You mean , the adhesive properties of the kapton tape will cause the gold plating on the gold finger to be somehow peel of
Electronics Forum | Fri Apr 13 12:37:35 EDT 2001 | edylc
>>> gold finger was covered by a Kapton tape and it was done offline away from the Screen printer or rather from the SMT lines itself, we are using an ENIG Pcb's , the process doesnt need a wave soldering ....however at the final end of the line ,
Electronics Forum | Thu Feb 01 20:21:34 EST 2001 | huat
Hi, Currently, we use kapton tape to tape out the goldfinger at our area. We still experience solder at goldfinger area, suspected is from washing of misprint boards. Can someone advice me on what is the method being use to clean the goldfi
Electronics Forum | Fri Apr 13 13:45:25 EDT 2001 | gsmguru
Just a guess-- Could you be seeing the nickel under the gold plating because you are removing some of the Gold with the Kapton Tape ? This should be easy to verify. Otherwise it sounds like things are pretty much covered.
Electronics Forum | Thu Jul 20 03:00:53 EDT 2006 | reypal
If you are using SMT machine for component placement you may check your nozzle where in some cases solder paste stuck to it and during placement will easily get into gold pad area. otherwise you have use kapton tape in order not to expose those pads.
Electronics Forum | Mon Jul 27 17:09:20 EDT 1998 | Rin
| We are trying to reduce the number of units fail at system test due to flux on gold finger. We know so far that the flux is deposited onto the | goldfinger during touch-up or rework and to reduce the contamination we are | planning to imp
Electronics Forum | Tue Jan 21 00:44:30 EST 2014 | leardkattiya
Hi All, I have a question to ask. Do we really need ESD kapton tape to be use inside SMT line/ production? Anyway the purpose of the kapton tape is to protect gold finger/ wirebond area from solder splatter. Please advise.
Electronics Forum | Tue Jan 21 13:40:00 EST 2014 | rgduval
If you're using the Kapton tape to protect the gold fingers from solder splatter, my first instinct is to say,yes, you do need it. I've had the pleasure of paying to have gold fingers reworked in the past. It is not in-expensive; certainly not equa
Electronics Forum | Sat May 13 07:03:16 EDT 2000 | Sal
guys, Currently running a very high volume product, with the gold fingers at the edge of the board masked off using Kapton tape to avoid any form of contamination during reflow and wavesoldering. I've heard alot of about the gold finger gloves, my q
winsouce.jpg)
