Electronics Forum | Wed Apr 18 08:14:20 EDT 2007 | davef
Silver palladium termination * AgPd-terminated capacitors are designed for conductive adhesion. Reflow or wave soldering is not recommended. [EPCOS Multilayer ceramic capacitors, Soldering directions, October 2006] * CONDUCTIVE EPOXY BONDING. Epoxy c
Electronics Forum | Fri Nov 23 16:09:01 EST 2007 | davef
We're not real clear about what you're trying to discuss, because most capacitors are packaged in epoxy with a solderable termination on each end. But lets throw a couple of ideas at the wall and see what sticks. If this epoxy is: * From the capaci
Electronics Forum | Tue Nov 27 14:56:33 EST 2007 | jaimebc
Shy, What is your current method of applying adhesive? If the terminals of the component that has adhesive are not wetting ( or not forming a solder joint I think we are talking about ) after reflow, then you must be applying too much adhesive. As
Electronics Forum | Mon Nov 26 20:11:41 EST 2007 | shy
Yes, i'm agree with you davef but i'm not put the chipbonders onto pads. i'm put the chipbonders at the beneath component (center between both component terminals) which the idea is to hold the component during wave soldering which might cause the co
Electronics Forum | Wed Nov 28 01:07:36 EST 2007 | shy
is there any standard gap between the terminal and pad if we place the glue? SMT-4 mention as per what you understand which is using glue at SMT without solder paste and run at wave solder for the solder paste at the terminal. Glue supplier recomm
Electronics Forum | Tue Nov 27 07:51:21 EST 2007 | shy
is there any gap between the pad and terminal if we place the glue? Btw, my practice to print solder pate then punch glue then PNP component and finally reflow. Also we find drop/missing chip after wave eventhough we glue the component.
Electronics Forum | Wed Nov 28 01:28:32 EST 2007 | shy
Q1:What is the relation between component standoff and drop missing? A1:component standoff will identify either solder paste at SMT side can form the fillet at component terminal or not. Drop/missing component is totally out of the topics since i jus
Electronics Forum | Mon Nov 26 22:05:34 EST 2007 | shy
currently i'm open my stencil aperture is 80% from the land pattern. is this will cause insufficient solder at the terminal component or not? the stencil thichness is 6mil and the board run using SMT pallet which i consider there will be no option f
Electronics Forum | Thu Nov 29 22:38:05 EST 2007 | shy
Hi Dback, Yes, i'm open "dog bone" aperture for my chip component. this is to prevent solder ball issue. For fine pitch i'm opening square with full length and half width to prevent bridging. Btw, if "dog bone" is not for chip component, what is your
Electronics Forum | Tue Nov 27 08:13:04 EST 2007 | davef
C1: is there any gap between the pad and terminal if we place the glue? R1: Yes, there is a gap, but it is easily bridged by the amount of solder in the wave. C2: Btw, my practice to print solder pate then punch glue then PNP component and finally
