Electronics Forum | Tue Jan 16 01:34:21 EST 2007 | ____
Pay up and get the info directly from Fuji.Its worth it in the end. Loop hole, purchase Flexa software and you get machine support.
Electronics Forum | Tue Jan 16 07:18:17 EST 2007 | jdengler
I got a manual for the TEAC unit (free from TEAC). Calibrated the unit to their specifications and it works properly now.
Electronics Forum | Tue May 22 09:37:11 EDT 2007 | jdengler
Hi Joakim, I do not know the QP242 table, but on our GP-341, CP-IV-2 and IP-III we make a plate from plexiglass with milled holes to show where the supports go for each board. This is not as fast as the Gridlock but does not cost nearly as much. J
Electronics Forum | Wed Mar 18 12:17:27 EDT 2009 | jdengler
Hi Chris, About 18 months ago I bought a LCD replacement monitor for our GP-341. It was easy to put in and cheaper than a new factory monitor. It's still working well for us and would recommend it to you. We got it from IBE. They advertise here
Electronics Forum | Tue Jan 09 13:54:10 EST 2007 | jdengler
Hi All, I'm having a problem with a Fuji GP-341. It has squeegee pressure control using a TEAC TD-320A comparator. I cannot get it to measure printing pressure. On the TD-320A it normally reads "2512" then flips to "oFl4" then back to "2512". If
| 1 |
