Electronics Forum | Mon Jul 10 13:08:21 EDT 2023 | ttheis
Thanks, I do recall reading about loading firmware onto some of the VME cards (VRM axis controllers I believe.) I will review this again. I agree that it seems to be some issue with reading axis position after hitting the home switch. The first thin
Electronics Forum | Wed Sep 19 16:20:46 EDT 2007 | highspeed
Can anybody tell me what an error code 6 means after a GSM Calibration.
Electronics Forum | Sat Sep 22 01:30:31 EDT 2007 | mika
I am sorry my friend, but I can't recall that specific error number. But it would help if you explain a little bit more about your problem. Remember that an error code Do Not necessary points to a direct root-cause of a problem. First of all we nee
Electronics Forum | Sat Sep 22 02:14:08 EDT 2007 | mika
Another thing to make sure of and the vision calibration system will fail if this is out of range: Use a magnet foot stand micrometer and measure the spindle run outs. First remove the nozzles and nozzle adapters, then put the adjustable tip (I dont
Electronics Forum | Wed Aug 12 18:06:33 EDT 2015 | bnorton
Here's the end of Logicomm capture on Force COMM2 where it starts the Lantern system not active messages. Couldn't get attach to work. Startup and earlier .ldx file loading omitted ulLoadTasks(): Opening the RFS pseudo device driver ... ulLoadTas
Electronics Forum | Tue May 03 10:51:41 EDT 2016 | swag
UIC'S newer software has a category you can change to force a part to the back during optimization for this very reason. I think it's done in placement list. Example: A part coded 1000 will place after a part coded 500. I don't recall what it is
Electronics Forum | Thu Mar 20 11:30:58 EDT 2014 | dave222
Hello Again. I little more information about the issue: when trying to zero machine head the spindles move up and down about 6 times before giving the error code. also I notice that all the LEDs on the circuit board are off. L11 - L18. and the nume
Electronics Forum | Wed May 02 12:22:30 EDT 2007 | SWAG
Make sure you get a good upward looking camera combo. 4.0 on rear and 2.6 for PTF (platform tray feeder) parts is my favorite. Easy to wrench on, calibrate (if you have a cal. kit), and easy to program. Single beam will run at 2000+ cph and dual b
Electronics Forum | Fri Jan 01 10:17:49 EST 2010 | jeffreyj
Long time no update. We ended up buying a used Quad IIc for something like $2500 + shipping - no kidding - through CAE. They originally wanted $5,200 but they wouldn't commit to saying it was operational and we wouldn't commit to buying it if they di
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
| 1 |
