Electronics Forum | Wed Dec 29 18:01:13 EST 1999 | JAX
What's happenin Larry, I am not sure if bump proccess E is available on this particuliar software rev. but I have forgotten?????? It shouldn't matter; bump proccess A will work fine. The only things you have to do is make sure the pick up point
Electronics Forum | Sat Mar 09 16:14:41 EST 2013 | dilogic
Machine -> Configuration -> Parameters -> Setup then go to vision setup page, if available. - Dejan
Electronics Forum | Mon Mar 04 19:05:44 EST 2013 | jaimebc
Deni, it is a 630 and there is text in the window, just no image of the component or anything else that is brought to the camera. It doesn't time out at all, it just moves the way it would when inspecting a component on test mode.
Electronics Forum | Sat Mar 02 18:02:26 EST 2013 | dilogic
Which vision does your machine have? I guess it is Lantern 630 or 640? Is there any text in the vision window after boot? regards Dejan
Electronics Forum | Fri Mar 01 10:45:54 EST 2013 | jaimebc
We currently have a problem with our Universal GSM 2. A part ins presented to the front or back camera but there is no image of the component. Just a dark screen, even though the light system is working. Any ideas on what the problem may be? I suspec
Electronics Forum | Wed Sep 21 15:13:08 EDT 2011 | gregcr
Where are you located? Along the same lines, I have a trick I used a couple times when replacing a camera. It is often not the image sensor that goes bad, but the camera electronics behind the sensor. I have had luck taking the camera apart but le
Electronics Forum | Thu Aug 09 15:16:20 EDT 2001 | Adam
Thank you Michael, yes we use a Fine Focus X-Ray machine, we also had some dummy connectors to play with, so we profiled the board until we reached a desirable profile. For placement we used a GSM machine, the only issue we ran into there is the par
Electronics Forum | Thu Aug 09 15:16:31 EDT 2001 | Adam
Thank you Michael, yes we use a Fine Focus X-Ray machine, we also had some dummy connectors to play with, so we profiled the board until we reached a desirable profile. For placement we used a GSM machine, the only issue we ran into there is the par
Electronics Forum | Fri Apr 02 14:11:21 EDT 2010 | bigdaddysoy9
Manjunath, I prefer orthogonal systems. In my experience they are actually better at detecting coplanarity and HIP defects than multi camera systems. They are obviously limited, in that they can not inspect a component under another component, b
Electronics Forum | Mon Mar 29 10:20:29 EDT 2010 | CL
Good Morning Mark, I do not believe that you can group images from multiple cameras. You can save a camera image into the library but you would need to re-name the part number for the side camera if you have an image from the downward looking camera